• No results found

Optimization Of ECM Parameters For Machining Ti-6Al-6V-2Sn

N/A
N/A
Protected

Academic year: 2020

Share "Optimization Of ECM Parameters For Machining Ti-6Al-6V-2Sn"

Copied!
5
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 6 Optimized Solution for Surface
Table 5 Optimized solution for ROC

References

Related documents

How does the status of  Wt1  so profoundly  have an impact on cells harboring an acti- vating  Kras  mutation? Vicent et al. show  that  the  loss  of  Wt1  

London surgeons in training those of the provinces.. It also enacted that only freemen of the Company could open barber's shops and.. that every surgeon must

And indicates percolation of heavy metals into the subsurface soils and contaminate the ground water in and around the waste dumping sites, and there is no proper management of

Feature level fusion refers to combining different feature vectors that are obtained by either using multiple sensors or employing multiple feature extraction algorithms on the

The Hospital Inpatient versus HOme (HIHO) study primarily aims to determine whether 10 days of post-acute inpatient rehabilitation followed by a hybrid home program provides

The adjustments to match Hadley with the adjusted XPM (and thus SII) are larger, particularly during summer (Ta- ble 2). This is because, as mentioned above, Hadley is more