• No results found

Analysis of heat transfer in spray cooling systems using numerical simulations

N/A
N/A
Info
Download
Protected

Academic year: 2020

Share "Analysis of heat transfer in spray cooling systems using numerical simulations"

Copied!
115
0
0

Loading.... (view fulltext now)

Download now ( 115 Page )

Full text

Loading

Figure

Figure 1.1 Comparison of heat transfer coefficient for different cooling techniques (Website: www.pitek.us)
Figure 1.2 Stages of spray formation and impact (a) spray formation and (b) spray breakup, impingement and film formation (Tropea, 2007)
Figure 1.4 Schematic illustration of spray cooling
Figure 1.5 Typical boiling curve and associated boiling regimes (Coursey, 2007)
+7

References

Download now ( PDF - 115 Page - 3.69 MB )

Outline

CFD Code Used in this Study Conclusions Recommendations for Future Work

Related documents

Analysis to Determine Heat Transfer Using Twisted Tape Inserts In a Horizontal Tube Suraj C Belagali & K Aparna

Analysis is carried out for plain tube with/without twisted tape insert at constant wall heat flux and different mass flow rates calculated for Reynolds number 7000, 9000,

Numerical Analysis of Heat and Mass Transfer Flow of Nanofluid over a Moving Wedge Using Spectral Quasilinearization Method

The aim of the present study is to analyze the effect of nanoparticle volume friction and the effects of various physical parameters on heat and mass transfer

Comparison on the Effect Of Regenerative and Sub Cooling in the Heat Transfer Characteristics of Semi Cryogenic Thrust Chamber Having Rectangular Cooling Channels by Using CFD and Numerical Analysis

The effectiveness of regenerative cooling of thrust chamber is carried out by considering aspect ratio 5. Regenerative and sub cooling studies show that the wall temperatures

Numerical Analysis of Influence of Thickness of Liquid Film on Bottom Cover to Heat Transfer in Thermosyphon in Conditions Emergency Modes of Work the Rechargeable Batteries of Aircrafts

NUMERICAL ANALYSIS OF INFLUENCE OF THICKNESS OF LIQUID FILM ON BOTTOM COVER TO HEAT TRANSFER IN THERMOSYPHON IN CONDITIONS EMERGENCY MODES OF WORK THE RECHARGEABLE BATTERIES

Analysis of fully developed flow and heat transfer through n-sided polygonal ducts with round corners using the Galerkin weighted residual method

Close agreements of the obtained results with those existing in the literature for the triangular and square ducts with round corners for the constant heat flux boundary condition

Comparison on the effect of regenerative and film cooling in the heat transfer characteristics of semi cryogenic thrust chamber having rectangular cooling channels by using cfd and numerical analysis

25892 Sarath Raj, Comparison on the effect of regenerative and film cooling in the heat transfer characteristics of semi cryogenic thrust chamber having rectangular