• No results found

Experimental examination of main cutting force and surface roughness dependingon cutting parameters

N/A
N/A
Protected

Academic year: 2020

Share "Experimental examination of main cutting force and surface roughness dependingon cutting parameters"

Copied!
8
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1. Kistler 9257A dynamometer and tke tool
Table 2. The cutting parameters used for the tests
Table 3. Main cutting forces obtained for different cutting speeds, feed rates and depth of cuts
Fig. 5. Cutting force variations depending on the cutting speed at 2 mm depth of cut when
+4

References

Related documents

A COMPARATIVE STUDY ON JOYFUL LEARNING IN GOVERNMENT AND PRIVATE EDUCATIONAL INSTITUTIONS OF PRIMARY EDUCATION IN PASCHIM MEDINIPUR DISTRICT IN WEST

(2006) investigated the influence of price and brand loyalty of three frequently purchased product categories on the purchase decision process of store brands

The top hits from virtual screening were then subjected to molecular docking using the CDOCKER protocol which is a CHARMm based docking tool that generates

ANSM: Agence Nationale de Sécurité du Médicament et des Produits de Santé; CPP: Comité de Protection des Personnes; CRC: Colorectal cancer; CRF: Case report form; CVP: Central

In existing system we define two approaches one is multiple classifier approach and the other is a single classifier approach and comparing them, for relative evaluation

Downlink compressive channel estimation with support diagnosis in FDD massive MIMO RESEARCH Open Access Downlink compressive channel estimation with support diagnosis in FDD massive

Although the earliest attested Dravidian loanwords do not appear in the Rigvedic texts until after 1500 BCE (Witzel 1999 ), it has been recently pointed out (Southworth and