A Theoretical Investigation on the Analysis of a Thermal Power Plant Working on Rankine Cycle

there exists pressure and temperature drop and the Tem- perature reduction valve is used to spray water to the main steam so that the main steam pressure and temperature are

In this paper we mainly concentrate on how to control and monitor the temperature, pressure and flow of steam, level in steam drum, RPM (Rotations Per Minute) of turbine shaft and

In steam power plant, the low pressure (LP) feed water heater are used known as Shell and Tube Heat exchanger which are the basic types of heat exchanger there are about three

For CHP applications requiring thermal products of low pressure steam and hot water, Low temperature fuel cells are applied while for high pressure steam

percentage of exhaust gas recirculation on steam extraction rate, net NGCC performances, as well as on the percentage incidence of the low-pressure turbine power with respect to

d) For any particular value of pressure ratio of topping cycle any particular value of pressure ratio of bottoming cycle, turbine inlet temperature of topping cycle, and any mass

much lower than that of small steam turbine (SST) driving feed water pump particularly in low load, and there are electro-. mechanical loss and power

Figure 4.4 also present a relation between regenerative gas turbine cycle thermal efficiency versus compression ratios for different ambient air temperatures, which