• No results found

CFD Analysis of Air Cooled Condenser by Using Copper Tubes and Aluminum Fins

N/A
N/A
Protected

Academic year: 2020

Share "CFD Analysis of Air Cooled Condenser by Using Copper Tubes and Aluminum Fins"

Copied!
15
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 4.1: Heat flux
Figure 4.2: Heat fluxAccording to the contour plot, at fins the maximum rate of heat transfer (heat flux) area is 1.12424and at outer surface the
Figure 4.4: Heat flux
Figure 4.6: Meshed model
+7

References

Related documents

In large horsepower (hp) applications (greater than 100 hp), gear systems tend to be designed for greater efficiency because of the costs, heat, and noise problems that result

To test whether the areas around the corridors had lower habitat suitability, we identified the area immedi- ately surrounding each corridor polygon (Additional files 1 and 4 ), with

To identify heterozygous gene deletions in yeast that support increased carotenoid, and conse- quently diterpene, production, we set out to develop a sys- tem to screen the

This study explored the perceptions of nurses in decision-making process in palliative care for patients with cancer. Eight themes emerged from this study included

Although we often think of stem cell therapy acting to regenerate tissue through cell replica- tion and then differentiation, growing evidence suggests that adult stem cells may

This article then inspires the constitutions of other countries in impeachment arrangements including Article 7A of the Third Amendment of the 1945 Constitution

At the c311 analyzer, Rack ID contains two kinds of information: Type of sample - 2 digits 20: Calibration 30: Control 40: STAT 50: Routine + Disk Position - 3 digits Note Because

1) After you have your pre approval in place it is a good time to meet with a realtor and have them assist you in your search of finding the right property for you.. We have a