• No results found

Static Power Side-Channel Analysis - An Investigation of Measurement Factors

N/A
N/A
Protected

Academic year: 2020

Share "Static Power Side-Channel Analysis - An Investigation of Measurement Factors"

Copied!
14
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1: Low-noise DC amplifier for static power measurements.
Fig. 4: Photographs of the complete setup including the DCamplifier, the low-pass filter, the board, the oscilloscope, theclimate chamber and some power supply units.
Fig. 7: Nibble-serial architecture of the PRESENT-80 thresh-old implementation core.
Fig. 9: Flowchart describing the measurement procedure.
+6

References

Related documents

Survey was performed involving all identified profes- sionals responsible for the PKU management in the countries from South-Eastern region of Europe (Albania, Bulgaria, Bosnia

And finding an optimal virtual network mapping for loading balance by using mixed integer linear programming (MILP) is computationally intractable. We propose efficient

BMI: Body mass index; CI: Confidence interval; FPG: Fasting plasma glucose; HAART: Highly active antiretroviral therapy; HDL-C: High-density lipoprotein cholesterol; HIV:

Principle of GPU programming with CUDA Host RAM GPU RAM Shared Memory GPU RAM Host RAM Blocks Data Transfer Ca lcul ati ons If possible: independent & identical threads +

Based on this index, we de-veloped ProMiSH-E that finds an optimal subset of points and ProMiSH-A that searches near-optimal results with better data structures

In this paper, proposed an Automatic Ration Materials Distribution Based on GSM (Global System for Mobile) and RFID (Radio Frequency Identification) technology instead of

Franchise system growth increases franchisor terminations of franchisees, but growth relying on governance, royalty rate, and clustering decrease it. Greater number of