• No results found

Target parameter estimation for spatial and temporal formulations in MIMO radars using compressive sensing

N/A
N/A
Protected

Academic year: 2020

Share "Target parameter estimation for spatial and temporal formulations in MIMO radars using compressive sensing"

Copied!
11
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1 Colocated MIMO radar setup
Fig. 3 MSE performance for θk estimation. Simulation parameters:L = 20, nT = 16, nR = 16, N = 512, θk ∼ U(−60◦, 60◦) but fallingoff-grid, βk = ejϕk where ϕk ∼ U(0, 1)
Fig. 4 MSE performance for βk estimation. Simulation parameters:L = 10, nT = 128, nR = 128, N = 512, θk ∼ U(−60◦, 60◦) but on-grid,βk = ejϕk where ϕk ∼ U(0, 1)
Fig. 7 Resolution comparison. Simulation parameters: L=256, nT =10,nR = 10, SNR = 0 dB (left), SNR = 25 dB (right)
+3

References

Related documents

In order to prove the efficiency of our method, an experiment of selecting better fit decision tree features for C5.0 was done, which has been used to classify

Researchers have proposed a variety of motion control methods, and the control algorithms of underwater which have been applied: PID control, improved PID

③ Real time data to be displayed on the electrical diagram of the distribution substation has been associated with the corresponding real-time data unique number, the browser will

Technology in our country at present, this aspect is still at the stage technology tracking, basically mastered by the United States, France and other western

After the success of the network training, there is a need to summarize the required fuzzy neural network with fuzzy rules. According to the membership func-

be seen from Figures 9(a) and 9(b) due to the redistri- bution of the flow channel of the metal flow, the local ends of the profile extrusion ratio increases, and both ends

The overall design of reflec- tive memory card hardware is shown in Figure 4, mainly including FPGA (register control, DMA, data transformation module and FIFO,

This article describes calculation formula of road- header cutting head torque based on the analysis of transmission structure and the data recorded in “black box”,