• No results found

Dorsal ventral patterning in amphioxus: current understanding, unresolved issues, and future directions

N/A
N/A
Protected

Academic year: 2020

Share "Dorsal ventral patterning in amphioxus: current understanding, unresolved issues, and future directions"

Copied!
11
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1. Simplified scheme of the Bmp, Nod-
Fig. 2. Distribution of selected components of signaling pathways during amphioxus early development
Fig. 3. Schemes illustrating sperm entry points in amphioxus zygotes according to divergent opinions (A,B)
Fig. 4. Cytoskeletal reorganization within the early amphioxus em-bryo. Red indicates the active Arp2/3 complex, and violet indicates Nodal mRNA
+2

References

Related documents

If the management fails to respond to observations within specified period of time, the FDA issues warning letters .If the response is unsatisfactory to the warning letters it may

A Monthly Double-Blind Peer Reviewed Refereed Open Access International e-Journal - Included in the International Serial Directories International Journal in Management and

A flagellar gene fliZ regulates the expression of invasion genes and virulence phenotype in Salmonella enterica serovar Typhimurium. Lin D, Rao CV,

The Mean enhancement time (MET), positive enhancement integral (PEI), a maximum slope of increase (MSI), and a maximum slope of decrease (MSD) values and the curve types of ROIs

Test is done with nominal concrete and 50% replacement of recycled aggregate for compressive strength for cubes and split tensile cylinder and flexural strength for beams at 28 day

DCs treated with OMVs containing PSA protect mice from experimental colitis, whereas Gadd45 α -/- DCs are unable to support T cell regulatory response and are defective in

LETTER Earth Planets Space, 60, 1011?1016, 2008 Source parameters of the 2007 Noto Hanto earthquake sequence derived from strong motion records at temporary and permanent stations

POCO EDM4 and POCO EDM200 The main purpose of this study was to investigate the influence of various parameters on the machining characteristics, namely,