CENTRIA FORMABOND Metal Composite Wall System
Full text
Related documents
This new composite beam system consists of three elements: reinforced concrete slab on corrugated cold-formed metal deck, back to back cold-formed steel joists, and
A secondary, cold formed horizontal structural member located in the roof to support sheeting, that is itself supported by the primary structure framing. Purlin
DRAINED AND VENTILATED CLADDING SIP WALL PANEL TOP PLATE ROOFING FELT DRYWALL SIP ROOF PANEL PANEL SCREW FINISHED ROOFING MATERIAL 8d COMMON NAILS @ 6" O.C.. EACH
The technique of combining a load-bearing wall concrete structure with a light-weight insulated timber frame (“non-structural”) exterior wall and a cladding of brick, render
The best practice for insulating metal framing is to install rigid insulation inside the exterior wall; more detailed information can be found in the section Envelope, INSULATION
Fig. 1.1 Composite construction for high-rise building structures ... 1.2 Girder-wall connections in the composite building structure in Fig. 1.3 Different girder-wall connections
Keywords: Hooked steel-GFRP composite connector, Precast concrete sandwich wall panels, Pull-out test.. 1
REFER TO SHEET S-001 FOR DELEGATED DESIGN NOTES AND S-002 FOR COLD-FORMED METAL FRAMING NOTES..