• No results found

Surface Roughness Analysis in High Speed Turning of Ti-6Al-4V Using Coated Carbide Inserts: Experimental and Modeling Studies

N/A
N/A
Protected

Academic year: 2020

Share "Surface Roughness Analysis in High Speed Turning of Ti-6Al-4V Using Coated Carbide Inserts: Experimental and Modeling Studies"

Copied!
20
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 2. Flank wear at different cutting speeds.
Fig. 4. Flank wear at different depths of cut.
Figure 6 shows the variation of cutting tool vibrations Vx, Vy and Vz with number of passes for different cutting speeds by maintaining a constant feed rate and depth of cut of 0.15 mm rev-1 and 1.2 mm respectively
Fig. 8. Variation of (a) Vx, (b) Vy and (c) Vz with number of passes at different depths of cut
+7

References

Related documents

M ERKL (4, HNHM); Pest m., Pilisszentlászló, Kopanyica, autós hálózás este [= netting with car at sunset], 28.. M ERKL (5, HNHM); Pest m., Pilisszentlászló, Sárkány-oldal,

The adjustments to match Hadley with the adjusted XPM (and thus SII) are larger, particularly during summer (Ta- ble 2). This is because, as mentioned above, Hadley is more

foco recae en el sintagma precopular, es decir, en el pronombre demostrativo, mientras que el sintagma lo que yo no entiendo de ti es presupuesto como topical (cf. Su empleo como

The top hits from virtual screening were then subjected to molecular docking using the CDOCKER protocol which is a CHARMm based docking tool that generates

• Despite several reviews (most recently, Dame Elish Angiolini, 2015), as well as changes in UK practice rape myth acceptance (RMA), varying levels of victim blame are still

Thus, in light of the currently inconclusive evidence on the potential impact of analgesic and anti- inflammatory drugs on bladder cancer occurrence, we assessed lifetime use of

Abstract —This paper presents an ultra-wideband (UWB) high temperature superconducting (HTS) bandpass filter (BPF) based on a ring resonator loaded with a pair of