• No results found

Surface Modification of Electrode Materials for Lithium-Ion Batteries

N/A
N/A
Protected

Academic year: 2020

Share "Surface Modification of Electrode Materials for Lithium-Ion Batteries"

Copied!
265
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1.1 Schematic illustration of the working principle of a Lithium ion battery
Figure 1.2 (a) The cost components of a representative graphite/NMC333 battery in 2013; (b) voltage vs capacity chart of main cathode materials (LNMO: LiNi0.5Mn1.5O4, LMO: LiMn2O4, LFO: LiFePO4, NMC: LiNi1/3Co1/3Mn1/3O2 up to 4.3 V, NCA: LiNi0.8Co0.15Al0.05O2) (c) crystal structure of LiFePO4 (d) crystal structure of LiMn2O4 and (e) crystal structure of LiCoO2
Table 1.1 Lithium ions diffusion in various categories of typical cathode materials
Figure 1.9 STEM-EELS study of Li1.2Ni0.2Mn0.6O2 and Al2O3 coated Li1.2Ni0.2Mn0.6O2
+7

References

Related documents

Lin et al Earth, Planets and Space 2014, 66 48 http //www earth planets space com/content/66/1/48 LETTER Open Access Thermal conductivities, thermal diffusivities, and volumetric

This paper studied the electrocatalytic oxidation of amaranth (AM), with a novel electrochemical sensor based on single- walled carbon nanotube-Titanium nitride (SWCNT-TiN)

In order to quantify the contribution of the CaP coating to barrier properties of the NiTi|CaP|physiological solution interface, EIS spectra were recorded on Nitinol with

Data obtained from chemical and electrochemical measurements were in good agreement with the results obtained from EFM.Tafel polarization studies have shown that L- arginine affects

dimensions of land, the dynamics approach reflects the fact that most property relationships are lived relationships, affected by changing patterns and understandings of spatial use,

Materials with high content of copper (W.Nr. 2.4360) showed highest weight loss at both temperatures during 72-hour period, due to the preferential selective

Figure 4 Latent and lytic EBV genes are co-expressed in gastric cancer. A portion of the heat map from Figure 1 is displayed in high contrast to decipher relative expression levels

It should be noted that the number of kinematic cutting scheme variants increases significantly in case of multi tool machining of a work piece (when there are two or more