• No results found

Design and Fabrication of an All Terrain Vehicle

N/A
N/A
Protected

Academic year: 2020

Share "Design and Fabrication of an All Terrain Vehicle"

Copied!
5
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig -2 : Front View Design of Steering Mechanism
Fig -5: Rear axle

References

Related documents

The Directors of Astro Japan Property Group Limited (ABN 25 135 381 663) ("AJCo") present their report together with the consolidated financial statements of AJCo and

horizontal ball joint play. If control arm support is not available, release tension from torsion bar. See STEERING KNUCKLE under REMOVAL & INSTALLATION. Using puller, remove

In order to define a complete voting scheme they have to be combined with other protocols for different requirements, for example a key exchange mechanism for threshold decryption,

[r]

Background: HER2/neu overexpression on cell membranes of breast cancer cells is due to HER2/neu gene amplification and it is important to identify potential candidates for anti

panel Handlebar and controls Front forks Frame Stand Clutch control Front brake Rear brake Front and rear wheels Rear wheel axle Rear subframe Number plate holder Rear

Note that the release of AgNPs from sand columns accounted for less than 2% recovery in step B (Figure 5.24), and the released AgNPs after cation exchange and IS reduction

From this equilibrium, the working point, the current through the valve and the voltage drop over the anode load resistor can be controlled by superimposing the input signal on the