• No results found

Deep Level Transient Spectroscopy in Quantum Dot Characterization

N/A
N/A
Protected

Academic year: 2020

Share "Deep Level Transient Spectroscopy in Quantum Dot Characterization"

Copied!
7
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1 Conduction band of the Schottky diode during the measure-ment phase. (a) Typical DLTS spectra from InAs/GaAs QD samplestaken at different revere bias voltages, V
Figure 3Arrhenius shows ee,1 and ep as given by Eqs. 1 and 3 inplotsassumingGaussianenergylevel
Fig. 3 Arrhenius plot of effective rates of thermal electron emissionfrom the s- and p-states calculated on the basis of Eqs
Fig. 5 Comparison ofexperimental (a) and theoretical(b) DLTS spectra in TVD-spacefor the InAs/GaAs quantum dotsamples calculated for QD datafrom Table 1

References

Related documents

Abbreviation: MDS, Minimum Dataset; ADL, Activities of Daily Living; GMPI, Geriatric Multidimensional Pain and Illness Inventory; GDS-15, Geriatric Depression Scale-15 short

Viewed from the perspective of existential phenomenologists‟ view of human nature, the study deductively identified three fundamental causes of student violence thus: the

This study, therefore set out to improve the synthesis of 1, study its crystal structure and geometry in both solid and free form state, analyse the frontier molecular orbitals

The Research on Nano medicine funding have led to creation of a modern treatment of cancer known as targeted cancer therapy, Which involves drugs that target

The results obtained show that the addition of the above mesh reinforcement has increased the impact residual strength ratio of geopolymer ferrocement by 4-28 that

This paper proposes a discriminative shared Gaussian process latent variable model (DS-GPLVM) for multi-view and view- invariant separation of facial expressions

Pharmacogenetics testing showed that ABCB1 (rs4148738) genotype distribution was as follows: 4 patients with wild genotype CC, 7 heterozygotes with a CT genotype, and 6

The purpose of using the transducers is to reduce the input voltage and current before reaching the signal processing circuit as all the components afterwards are IC based