• No results found

Cutting Parameters Optimization for Surface Finish and Machining Time in turning of OHNS O1 grade Hardened Tool Steel for Near Dry Machining

N/A
N/A
Protected

Academic year: 2020

Share "Cutting Parameters Optimization for Surface Finish and Machining Time in turning of OHNS O1 grade Hardened Tool Steel for Near Dry Machining"

Copied!
8
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig -1: Co-axial pipe arrangement in NDM setup
Table -3: Coded Coefficients for RaMQL versus SPEED, FEED, DoC
Table 4: Analysis of Variance for Tc versus SPEED, FEED, DoC
Fig -5 : Response Optimization by Minitab 17 for minimization of Tc (Machining Time) and Surface Roughness Ra by RSM Response Optimizer for SPEED, FEED and DoC

References

Related documents

A regular symmetric full-length service and a short turning service between Stations 2 and n-2 are illustrated in Fig. The vertical axis represents travel time from ori- gin

To prevent Road Traffic Injury on roads in our State, we should consider and use sustainable safety programme of different countries as per our requirements

BDNF: Brain-derived neurotrophic factor; CRF: Case report form; CRS-R: Coma Recovery Scale-Revised; CS: Conscious state; DRS: Disability Rating Scale; FAM: Functional

On analysis of the SRM extraction process, we employ optimization technology including convolution unrolling, combined memory access, split-merge strategy for Co-

Ten mutant groups exhibit both wild-type neuronal patterning and BrdU incorporation, indicating that the glossy-eye phe- notype is due to mutations in genes that function after

120 adult and juvenile animals from the quarantine center Mangily/Ifaty (30 km north of Toliara) and 24 resident animals from Ampotaka and Tranovaho will be selected in the

The human endothelin-1 (ET-1) gene under the control of its natural promoter was transferred into the germline of mice. The transgene was expressed predominantly in the brain, lung,

( B ) Western blot analysis of active beta-catenin and total beta-catenin level after 90-min treatment with K34c integrin antagonist (20 µM). Relationships between α5β1 integrin