• No results found

The Effect of the Thickness-to-Die Diameter Ratio on the Sheet Metal Blanking Process

N/A
N/A
Protected

Academic year: 2020

Share "The Effect of the Thickness-to-Die Diameter Ratio on the Sheet Metal Blanking Process"

Copied!
9
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1.  The blanking setup for simulations
Fig. 2.  The geometrical model of the blanking process and the FEM meshes of the workpiece
Fig. 4.  Engineering and true stress-strain curves of AISI 304
Fig. 8.  Punch load difference between experimental and simulation results. (t/Dm=1/10, clearance: 5 %)
+3

References

Related documents

infected HeLa cells , fused in a minimal reaction resulting in binucleated or trinucleated syncytia. Nor- mal heteroploid cells adsorbed with para-infiuenza

Antihypertensive therapy in hypertensive patients imme- diately post stroke may be effective and cost-effective compared with placebo from the acute hospital perspec- tive at

Mercer, Refined arithmetic, geometric and harmonic mean inequalities, Rocky Mountain J. 33

IL-23 measured by qPCR from RNA extracted from 24 h PPD-J stimulated PBMC isolated from HAV vaccinated (triangles) or Sham vaccinated (squares) calves, taken immediately prior to

The most important contributions of this paper are (i) the proposal of a concern mining approach for KDM, what may encourage other groups to start researching on

Conclusion: Although it revealed the presence of low and excess birth weight, this study has shown that maternal anthropometry and dietary diversity score were

A good example of these new compounds is ferric carboxymaltose (FCM), which has recently been approved by the US Food and Drug Administration for the treatment of iron

Notes: In addition to being an alternative bactericidal mechanism of clinically traditional antibiotics, ROS generation is the antimicrobial mechanism of HBOT, medical honey,