• No results found

Modelling and analysis of tool wear and surface roughness in hard turning of AISI D2 steel using response surface methodology Pages 63-74 Download PDF

N/A
N/A
Protected

Academic year: 2020

Share "Modelling and analysis of tool wear and surface roughness in hard turning of AISI D2 steel using response surface methodology Pages 63-74 Download PDF"

Copied!
12
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 1 Workpiece material and cutting tool descriptions
Table 3    Experimental results for tool wear and surface roughness parameters Run.no Machining parameters
Table 4  ANOVA results for tool wear (VB)
Fig. 1. Comparison between measured and predicted values for tool wear Fig. 2. Comparison between measured and predicted values for surface roughness
+4

References

Related documents

and 4.2 , these test results show that the water absorption ratio of aggregates and the mixing effect caused by high pressure and shearing inside the pump can change the

For desired initial and final Cartesian positions of the toe of the swing foot, compute the initial joint posi- tion vector ф in and the final joint position vector ф f using

On analysis of the SRM extraction process, we employ optimization technology including convolution unrolling, combined memory access, split-merge strategy for Co-

In the first part, the students were given 10 sentences and asked to form nouns and verbs out of given underlined words whereas the second part included 10 sentences in which

Abstract —This paper presents an ultra-wideband (UWB) high temperature superconducting (HTS) bandpass filter (BPF) based on a ring resonator loaded with a pair of

In the fully Bayesian statistical infer- ence the t-channel signal strength is extracted simultane- ously by using either the BDT or NN discriminator output in the two signal

Therefore, at UPEI significant differences in factors exist for variables such as gender (vigour and depression), year of study (fatigue, tension and depression), degree (anger,