• No results found

Kirchhoff plate modelling using finite element method

N/A
N/A
Protected

Academic year: 2020

Share "Kirchhoff plate modelling using finite element method"

Copied!
22
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1.1  Steps in engineering mechanic analysis
Figure 1.2 Illustration of modelling steps
Figure 1.3 Finite element mesh of the structural part of a car

References

Related documents

Assessment of these sub- dimensions would demonstrate that expansion of companies to numerous different countries in foreign sales based on both time and geographical coverage,

Where the river passes through Rothamsted land (Flint Field) it flows over topsoil which has been described as a sandy silt loam to silty clay loam, mainly humose and

Since tremor frequencies of PD and ET can overlap with range from 4 to 8 Hz [ 7 ], and to exclude low frequency high amplitude signal caused by movements while performing

The developed vehicle tracking system uses Global System for Mobile communication/General Packet Radio Service (GSM/GPRS) and Global Positioning System (GPS) technology is used

In this model, saliency regions are obtained by Fourier spatial and temporal spectral residual, saliency objects are generated by using a object detection method based on the

Essential cupping is indicated to treat the specific ailments, described by eminent Unani scholars.. For voluntary cupping induction there are ten specific

Color moment, LBP and parameters of the images are used for extracting the color, texture and shape respectively and after this these features are combined for designing a

Approximately 6,773 students (3,931 undergraduates and 2,802 graduate and professional students), representing every state and 65 countries, are currently enrolled in CU’s