• No results found

Frictional and Wear Behavior of Commercially Pure Ti, Ti 6Al 7Nb, and SUS316L Stainless Steel in Artificial Saliva at 310 K

N/A
N/A
Protected

Academic year: 2020

Share "Frictional and Wear Behavior of Commercially Pure Ti, Ti 6Al 7Nb, and SUS316L Stainless Steel in Artificial Saliva at 310 K"

Copied!
10
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 2 shows the representative ®­L curves obtained
Fig. 4. In this graph, the values of ® 0 of SUS316L and CP Ti
Figure 5 shows the variation of the proportional volume loss of the alloys, V/(WL), against the dead load, W
Fig. 6 Surface morphology and pro files of the wear tracks obtained in water and AS under a dead load at 2.94 N.
+6

References

Related documents

Among the testers, T 1 was considered good general combiner for yield, fruit length, fruit weight, number of primary branches, number of fruits per vine, ascorbic

This paper is aimed to define strategic planning in civil aviation and its importance in civil aviation in Kyrgyzstan, as well as emphasize the three main steps to be taken

While we have not created an application that solely uses the Leap Motion device, certain actions are not easily performed with the Leap, such as text input. However, we have

While games of various types have been used in education since schooling began—including individual and team sports, board games (e.g., chess), and games created

+ZIONSVILLE ATHLETIC BOOSTER CLUB SCHOLARSHIP: One male and one female senior athlete will be awarded a 1,250 non renewable scholarship based on athletic participation,

INTERNAL REPORT NO.. Longuet-Higgins uaing a double series. Formulae for the

It was imperative that furnishings would provide long lasting support, flexibility, and durability – Sync and the Neighbor™ Collection by Steelcase Health, a family of

ABSTRACT : Adiabatic array logic allows designing low power digital circuits with more power saving despite having an equal number of transistors with the conventional CMOS logic