• No results found

Microstructure and Mechanical Properties of Cu 40%Zn 0 5%Cr Alloy by Powder Metallurgy

N/A
N/A
Protected

Academic year: 2020

Share "Microstructure and Mechanical Properties of Cu 40%Zn 0 5%Cr Alloy by Powder Metallurgy"

Copied!
6
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1SEM images of raw brass powders of Cu­40Zn (a) and Cu­40Zn­0.5Cr (b) made by water-atomization.
Fig. 3EBSD analysis results of extruded brass alloys using Cu­40Zn (a) and Cu­40Zn­0.5Cr (b) alloy powders.
Table 2Changes in lattice constant of extruded brass alloys with variousextrusion temperatures.
Fig. 7Dependence of X-ray diffraction angles of main peak of ¡ phase (a) and ¢ phase (b) of extruded brass alloys on extrusiontemperature.

References

Related documents

Consumer Satisfaction affects the bank's customer switching behavior. Consumer Satisfaction affects the bank's

Although previous studies have reviewed the impact of teachers‘ demographics and gender in the lower grades (Acker, 2006; Milner & Hoy, 2003; Warren, 2002), a void

Experimented at different thermal loads with two different PCMs (Water and Eutectic solution (90% H2O + 10% NaCl) of melting point 0°C and -5°C respectively) which shows the

Multiscale entropy (MSE) has been used to identify differences in fluctuations of postural CoP time series between groups with and without known physiological impairments at

The second-order factor analysis grouped the eight first-order factors into three broad constructs, namely (with first-order themes in parentheses), intrinsic motivation

7 Estimation of infection rate of schistosomiasis from 2011 to 2015 in Dantu County, Jiangsu Province, People ’ s Republic of

1 MSc, Occupational Environment Research Center, Rafsanjan University of Medical Sciences, Rafsanjan, Iran• 2 Medical student, Faculty of Medicine, Rafsanjan University of