Impact Toughness of Weldments in Al Mg Si Alloys

In addition, high Zn (8.20 wt.%) and high Sc (0.87 wt.%) content of Al-Zn-Mg alloys in connection with FSP (with optimum process parameters) may result in improved

The (0002) pole figures of the rolled and subsequently annealed Mg-Zn and Mg-Zn-Ca alloys are shown in Fig. The intensities of basal texture for the Mg-Zn-Ca alloys were much lower

Mg alloys are easily oxidized and burned when they are exposed to high temperature of fire. 1–3) Ignition of Mg alloys has been studied for the past several decades but has

In the alloys with Mg(0.25–0.5 mass%) and Si(0.2–0.4 mass%), the unidirectional pores were aligned between columnar dendrites grown in the unidirectional solidification. With higher

In the present study, the work on the microstructure, mechanical and tribological properties of spray deposited Al 17%Si and Al-17%Si-10%Sn alloys are summarized

In this study, the effect of strain rates on tensile properties and work hardening behaviour were evaluated for extruded Mg-Al-Zn alloys.. Further, the fracture behaviour

Therefore, it can be stated that the MRI230D Mg alloy can be used for superior temperature applications when compared to the AZ91D and MRI153M Mg alloys.. time plot

Figure 5.24 (Continued) Tensile properties of Mg alloys with and without Bi modifications: c) Fracture elongations. The results of the fracture tensile strength in the 10Mg alloy