• No results found

Experimental study of friction in aluminium bolted joints

N/A
N/A
Protected

Academic year: 2020

Share "Experimental study of friction in aluminium bolted joints"

Copied!
8
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1. Example of bolted joints in front motorbike suspensions: (a) steering plate-leg, (b) leg-wheel pin
Table 1. The Design of Experiment (DOE) parameters: variables and levels.
Table 2. DOE plan and results provided by experimental tests (T=15Nm)

References

Related documents

The minimal time an investigator has to wait is the time needed to perform the next step. Additionally, if that step is completed outside of working hours,

The house, built in 1911, is an early Vancouver home, valued for its association with the growth and development of the Cedar Cottage neighbourhood, once part of the

The fi ndings of this investigation clearly asserted that (I) BDNF levels were lowered in Wet-AMD but not in Dry- AMD patients, (II) the CRP expression was elevated in Dry-AMD

HPC International Desks Director Leads One Day Workshop - Michel Davison, HPC International Desk Director, was the primary speaker at a one day NOAA sponsored numerical

the information together to identify typical human functional failure generating scenarios for primary active road users in accidents where inappropriate speeding is a cause,

Interviews were conducted before and after intervention using a physical restraint questionnaire to examine any change in staff knowledge, attitudes, and behaviours on physical

Under the corporate governance code and company law, companies are governed by a board of directors (sometimes confusingly called the supervisory board) with both