• No results found

Numerical Analysis Of Thin Layer Drying Kinetics Of Untreated Carrot Slices Using Photovoltaic Thermal Solar Dryer

N/A
N/A
Protected

Academic year: 2020

Share "Numerical Analysis Of Thin Layer Drying Kinetics Of Untreated Carrot Slices Using Photovoltaic Thermal Solar Dryer"

Copied!
7
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1. Schematic diagram of Photovoltaic Thermal hybrid Solar Dryer assisted with ETC
Fig. 3.2. Moisture Ratio Vs Drying Time for PVT – Hybrid Solar Dryer and Sun Drying
Fig. 3.3. Photograph of untreated carrot slices before drying
Table 3.2 Results of mathematical models of photovoltaic thermal hybrid solar dryer with ETC for drying of untreated carrot slices

References

Related documents

In this study, a recombinant VP2 protein antigen based on a wild-type Finnish AMDV strain and subsequently an ELISA- based method for detecting AMDV antibodies in minks were

Key words -Mobility Degradation Factor, Nanowire, Series Resistance, Gate-All-Around (GAA) Silicon Nanowire Metal Oxide Semiconductor Field Effect Transistor (SNW-MOSFET).. I

The objective of the Smart City, Just City initiative is to develop and advance a policy framework that uses smart city techniques to attain a ‘just city’ vision of an equitable,

The average Remanent Magnetization at various milling hours is tabulated in Table V and is shown in Fig.16 It is maximum at the end of 2 hours of milling compared to Ni and Fe

Edge detection is applied to find the fracture in a bone in the body (like skull, Hand, and Leg, Wrist, Bar room fracture, Chest, and Spine).Fracture is a medical situation in

Orthostatic hypotension(OH) was present in one quarter of outpatients with stroke, and coronary artery disease appeared to be a risk factor, suggesting

environmental suitability. Higher standards of living are in conjunction with greater potential spending on commodities with greater added value, together with better

In this paper, the rigid-discrete coupling simulation model of scraper conveyor is established based on the discrete element method and the multi-body dynamic method, and the