• No results found

Low Voltage High Speed 8T SRAM Cell for Ultra Low Power Applications

N/A
N/A
Protected

Academic year: 2020

Share "Low Voltage High Speed 8T SRAM Cell for Ultra Low Power Applications"

Copied!
7
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1: Standard 6T SRAM Cell.
Fig. 3: Proposed 8T SRAM with Read Assist.
Fig. 6: Waveform of Conventional 8T SRAM Cell.
Table 2: Depicts the Total Power Consumption of the SRAM Cells. The Proposed  SRAM  Cell  Designs  Have  Less  Power  Compared  to  Existing SRAM Cells
+2

References

Related documents

Prosthetic repair with synthetic mesh is recom- mended for patients with intestinal incarceration and no signs of intestinal strangulation or concurrent bowel resection (clean

SAFT image of 50 mm dia circular void located at the mid-depth of a 350mm thick concrete slab using

2.3 Factors that contribute to size-dependent properties of piezoelectric nanomaterials: surface effects and flexoelectricity. 2.3.1

The isogeny computation is described in Section 4, and the special case of Jacobians of genus 2 hyperelliptic curves where we have complete formulae for the conversion between

Figure 6 shows the relative frequency distributions for the minimum TB at the time of the A-Train overpass (snapshot T B , solid) and the minimum T B over the entire lifecycle

Critical to accurate system studies is an accurate model of the interconnection-wide Network Model (i.e., transmission liens, generation), and Energy Management System (EMS),

Therefore, in order to reduce emissions during the actual operation of mobile machinery, Chinese non-road diesel mobile machinery emission standards should focus on the

Patients and methods: Twenty-four paired primary and corresponding metastatic tissue samples from eight nonresponding and four responding metastatic colorectal cancer