• No results found

Discrete element modelling and cavity expansion analysis of cone penetration testing

N/A
N/A
Protected

Academic year: 2020

Share "Discrete element modelling and cavity expansion analysis of cone penetration testing"

Copied!
27
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 2. Particle and wall properties for DEM simulations.
Table 3. Summary of CPT simulations.
Table 4. Material properties for analytical solution of CPT and analytical and DEM tip resistance values
Figure 2 Boundary conditions for cone penetrometer
+7

References

Related documents

replace this with a toilet that uses 6 litres of water per flush, your total indoor use of water will be reduced by approximately 30 percent.. • Consider installing a

The results suggest that under the assumption of error independence among the three output functions, social capital does indeed significantly impact innovation output. While not all

If a risk based view of defence industry capability were developed as advocated in the ABDI submission to DWP 2015, and as summarised in the preamble to this submission, the level

Extreme value theory has been used to get information about the tail of the particle size distribution in the case of spherical particles, under the assumption that the radii of

that “journalism over Europe is emerging as a common transnational experience”, whereas “the EU news appears restricted to the elite readerships of press” (Mapping the

In mitosis chromosomes separates and form into two identical sets of daughter nuclei, and it is followed by cytokinesis (division of cytoplasm). Basically, in

This paper presents the performance and emission characteristics of a CRDI diesel engine fuelled with UOME biodiesel at different injection timings and injection pressures..

Additional benefits that were seen from the project: the new skills and confidence gained by students, students' increased understanding and use of ePortfolios and