• No results found

Performance Capabilities of EDM machining using Aluminum, Brass and Copper for AISI 304L Material.

N/A
N/A
Protected

Academic year: 2020

Share "Performance Capabilities of EDM machining using Aluminum, Brass and Copper for AISI 304L Material."

Copied!
6
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 2 is the experimental Set up of EDM.
Fig. 3 EDM process.
Fig. 4  Tool Work piece Pair before machining

References

Related documents

Raw data for the study of association between pre-operative medication use and post-operative delirium in surgical oncology patients receiving comprehensive geriatric assessment..

An argument is made that depres- sion can be viewed as a modifiable inde- pendent risk factor for development of type 2 diabetes and for progression of complications from either type

Channel performance parameters of path loss in terms of path loss exponent, net received power, free space path loss profile varies with

Our repeated subsequent visit to the sampling site revealed that due to non-operation of mercury free gold extraction facilities and government prohibition of artisanal

Because integrin β1 was associated with sustained motility and activation of PI3K-AKT signaling as well as increased formation of stress fibers following MEK inhibition

WORLD JOURNAL OF SURGICAL ONCOLOGY Chen et al World Journal of Surgical Oncology 2013, 11 255 http //www wjso com/content/11/1/255 RESEARCH Open Access Clinical features and outcomes of

40623 2015 Article 620070555 pdf Earth Planets Space, 62, 555?566, 2010 Deep crustal structure around the Atotsugawa fault system, central Japan A weak zone below the seismogenic zone

We used ordinal logistic regression because Fazekas scores are ordinal data, and we estimated the odds ratio (OR) associ- ated with increasing Fazekas score for an increase of 1 ml