• No results found

An Airborne VHF Printed Monopole Antenna for Platform Constrained Applications

N/A
N/A
Protected

Academic year: 2020

Share "An Airborne VHF Printed Monopole Antenna for Platform Constrained Applications"

Copied!
11
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1. Antenna evolution.
Table 1. Comparison on the height reduction and bandwidth of antennas in evolution process.
Figure 3. Structure of proposed antenna; (a) Radiating patch. (b) Ground patch.
Figure 4. Photograph of fabricated antenna.
+6

References

Related documents

trains from the generator shaft position sensors (a), produced pulses by the controller circuit after 15 o and 23 o degrees firing angle adjustments (b), power transistor on

things and artifacts to posit that artifacts have internal teleology just as living

Thus the physical and mechanical properties of Geogrid were found to considerably increase the Compressive and Flexural strength of Aerated light weight concrete

Because of this, the signature of balancing selec- tion may be weaker in partial asexuals than in selfers if the rate of biparental reproduction is very small (Figure 6), even

The two multivariate methods primarily used to predict fuel compositions are principal components regression (PCR) and partial least squares regression (PLS). The

people lived in rural areas, often far away from the major cities of the Netherlands. Throughout the war, they always seemed to have enough to eat, although

The results of the preliminary simulation show that the FDS program is a tool usable in simulating the two-phase flows involving high-speed droplets provided that the initial

I understand the information provided for the studyOf Chinese Immigrant Parents’ Communication with Their Children’s School Teachers: Experiences, Expectations and Challenges