Abramson et al. (2001)-Slope Stability and Stabilization Methods.pdf

2.2 Interaural intensity differences are created when the head 5 creates a "sound shadow" on the side opposite the sound source.. 2.3 Developed

Single-factor experiments were carried out, where a Plackett–Burman design was used to screen out three factors from the original six factors of processing wastewater

Our resource model described in section 5.2, highlights the resources and their interaction. In regards to our implementation, the resources have been defined as single resources.

Leaves, stalks, and cobs from two Bt corn hybrids (Pioneer 34N44 Bt and NC+ 4990 Bt) and their non-Bt isolines (Pioneer 34N43 and NC+ 4880) were analyzed for biomass fractions

Based on the algorithm we proposed, we can easily find three factors, tracking distance, image acquisition speed and reference image position, may affect the

Phenol has the largest peak area, which is in line with those reported by Soldera (2008) stated that the phenol and its derivatives is the largest component

We used both models to investigate the effect of important polymerization parameters, namely catalyst feed rate and hydrogen concentration, on the product polypropylene

daily dietary intake values of detected pesticides in this study were observed below the recommended ADI val- ues in all five sites at both lower bound and upper bound scenarios