• No results found

►The Nature of Waves ►Tides

N/A
N/A
Protected

Academic year: 2021

Share "►The Nature of Waves ►Tides"

Copied!
27
0
0

Loading.... (view fulltext now)

Full text

(1)

Chapter Topic Menu

Choose to view chapter section with a click on the section heading.

►The Nature of Waves

►Tides

(2)

Anatomy of a Wave

A wave is the transmission of energy through matter. Key word is “through.”

When energy moves through matter as a wave, matter moves, but overall doesn’t shift forward or backward. It transmits the energy to adjacent matter, allowing the energy to continue.

● There are three types of progressive waves:

1. Longitudinal waves move through all states of matter and occur when energy moves in the same direction that the energy travels.

2. Transverse waves only transmit through solids. They occur when the energy motion is perpendicular to the travel direction.

3. Orbital waves only transmit through fluids. They occur when the energy moves the fluid in a circular motion as it passes.

The Nature of Waves Chapter 10 Pages 10-3 to 10-5

(3)

Anatomy of a Wave

Crest – highest point above average water level.

Trough – lowest point below average water level.

Height – vertical measurement from trough to crest.

Wavelength – horizontal distance between the identical point of two waves.

Period – time it takes for the same spot on two waves to pass a single point.

Frequency – the number of waves that pass a fixed point in one second.

The Nature of Waves Chapter 10 Pages 10-3 to 10-5

Speed = wavelength / period This is sometimes abbreviated:

S = L / T

(4)
(5)

Wave Causes and Characteristics

Disturbing forces cause waves – wind, gravity, and seismic activity.

Restoring forces resist waves – surface tension, gravity, and Coriolis effect.

Deepwater waves occur in water that is deeper than half their wavelength, the bottom does not affect their

orbital motion.

Shallow-water waves occur in water that is shallower than half their wave- length, the bottom creates drag that affects their orbital motion.

Three factors affect maximum

wave size: wind speed faster than the wave, wind duration (time wind blows), and fetch (surface area over which wind blows).

The Nature of Waves Chapter 10 Pages 10-5 to 10-8

(6)

Wave Causes and Characteristics (continued)

A fully developed sea can have waves larger or smaller than the maximum theoretical size.

If waves are in phase, wave energies are constructive and combine into larger waves.

If waves are out of phase, they can cancel each other out.

The Nature of Waves Chapter 10 Pages 10-8 to 10-10

(7)

Wave Causes and Characteristics (continued)

Internal Waves

● Internal waves are found inside the ocean. They can occur within different density layers. These waves can be as much as 30 meters (100 feet) tall.

Internal waves are found below the surface.

The wave motion in a deep layer can cause a thermocline or halocline to slowly rise and fall as the wave passes.

Scientists don’t exactly know what causes internal waves. It is likely they get their energy from wind, gravity, or seismic forces, just like surface waves.

The Nature of Waves Chapter 10 Pages 10-8 to 10-10

(8)

Surf and Breaking Waves

● In deep water, a wave breaks when its height exceeds one-seventh of its wavelength – H:L ratio exceeds 1:7.

Due to drag from the seafloor, the bottom of the wave slows so that the top of the wave is traveling faster than the bottom. This, and exceeding the 1:7 ratio, makes the wave break, toppling the upper part of the wave forward.

The Nature of Waves Chapter 10 Pages 10-12 & 10-13

(9)

Surf and Breaking Waves

● There are three basic types of wave breaks:

1. Plunging breakers are characterized by a curl as the top of the wave pitches through the air before splashing into the bottom. They occur on moderately steep beaches.

2. Spilling breakers are characterized by the top of the wave tumbling and sliding down the front of the wave as it decelerates slowly. They occur on beaches with a gentle slope.

3. Surging breakers occur on very steep beaches that are almost like walls. Because they do not slow, they surge virtually unbroken and can be very destructive.

The Nature of Waves Chapter 10 Pages 10-12 & 10-13

Spilling Breakers Surging Breakers

Plunging Breakers

(10)

Surf and Breaking Waves (continued)

● Waves rarely hit the shore squarely. Refraction, diffraction, and reflection affect wave behavior.

On an irregular shoreline, refraction concentrates wave energy toward protrusions because the side of the wave nearest to the protrusion slows first, turning the wave toward it.

Wave diffraction occurs when waves hit an obstacle, such as a jetty. Energy shifts within the wave, allowing a new wave pattern to form past the obstacle or through an opening.

The Nature of Waves Chapter 10 Pages 10-13 & 10-14

(11)

Surf and Breaking Waves (continued)

● Reflection can cause a standing wave. This wave is a vertical oscillation in which water rocks back and forth, rising and falling at the ends, but relatively motionless near the center.

● Imagine sliding back and forth in bathtub and the waves created

The Nature of Waves Chapter 10 Pages 10-13 & 10-14

Reflection occurs when waves hit an abrupt obstacle that is nearly perpendicular in the water, such as a sea wall. Reflected wave energy can bounce around the sides of an enclosed area, creating complex wave patterns.

(12)

Destructive Waves

● 1. Storm surge is a destructive wave that forms when high winds push water against the shore, where it piles up. The shallower the water offshore, and the further it extends offshore, the greater the surge.

The Nature of Waves Chapter 10 Pages 10-15 to 10-17

http://www.geocities.com/CapeCanaveral/7639/oceans/jb_storm_surge_after.gif http://www.geocities.com/CapeCanaveral/7639/oceans/jb_storm_surge_before.gif

BEFORE

AFTER

(13)

Destructive Waves

● 2. Seiches form in bodies of water smaller than an ocean as a wave that rocks back and forth. It results from a strong wind that pushes the water level up on one side of a lake or basin.

The Nature of Waves Chapter 10 Pages 10-15 to 10-17

(14)

Destructive Waves

● 3. Tsunamis result from sudden water displacement caused by a landslide, iceberg, volcanic eruption, or, more commonly, an earthquake.

Tsunamis are always shallow-water waves. Their wavelength is about 200 kilometers (120 miles), there is no ocean deep enough to make a tsunami behave as a deepwater wave.

Tsunamis have very long periods and they are so huge that they are nearly imperceptible as they travel. Boats at sea may rise and fall several meters as a tsunami passes, but cannot detect it had passed under them.

The Nature of Waves Chapter 10 Pages 10-15 to 10-17

(15)
(16)

Indonesia Tsunami

December 26, 2004

(17)
(18)
(19)
(20)

What causes the

change in water

level in these two

pictures?

(21)

The Cause of Tides

Tides result from the gravitational pull of the moon and, to a lesser degree, the sun.

Isaac Newton proposed the equilibrium theory as an explanation for the tides.

His theory assumed that the Earth is perfectly uniform, that water is very deep, and that there are no landmasses. The problem with this theory was that it was too simplistic.

Pierre-Simon Laplace modified Newton’s model to account for tidal variations.

Laplace’s model is called the dynamic theory which shows that there aren’t only two tidal bulges; rather, there are several tidal bulges.

Tides Chapter 10 Pages 10-19 & 10-20

(22)

The Cause of Tides

● Besides lunar and solar gravity, the imperfect sphere of the Earth, the season, the shape of the ocean basin and the Coriolis effect, all influence the tides.

● Tides rotate around more than a dozen amphidromic points. These are points where the water doesn’t rise and fall with the tides.

Tides Chapter 10 Pages 10-19 & 10-20

(23)
(24)

Tidal Patterns and Currents

A diurnal tide is having a single low and high tide daily (Gulf of Mexico).

A semidiurnal tide is having two roughly equal high and low tides daily (East coast of the US).

A mixed tide is having two unequal high and low tides daily (West coast of the US).

Tides Chapter 10 Pages 10-21 & 10-22

(25)
(26)

Tidal Patterns and Currents

The daily tides create a current that flows into and out of bays, rivers, harbors, and other restricted areas.

The inflow of a tide is the flood current, the outflow is a slack current, the midpoint is a slack tide.

A tidal bore forms when the incoming tide produces a wave that flows into a river or other narrow area. This is a true tidal wave and can be several

meters/feet high in places (Amazon River).

Tides Chapter 10 Pages 10-21 & 10-22

http://www.tsunamis.com/tidal-bore-illustration.gif

(27)

The Sun, Moon, and Types of Tide

● When there’s a new moon (no moon visible), both the sun and moon are aligned on the same side of the Earth.

● During a full moon, the sun and moon are aligned on opposite sides of the Earth.

Both positions create the highest and lowest tides, called spring tides.

● When the moon is in a quarter moon phase, it and the sun are at a right angle to the Earth.

The sun’s gravitation pulls to the side of the moon’s tidal bulge.

This tends to raise the low tide and lower the high tide. These weaker tides are called neap tides.

Tides Chapter 10 Pages 10-23 to 10-25

References

Related documents

Conclusions: In this rural Chinese population aged ≥ 30 years, MetS and microalbuminuria were independently related and the combination of high CRP and MetS was associated with

This is looked at with regard to both the ‘process of recording’ and at the information that is kept on the (legal) tenurial relations between persons and land. Later on these will

In this paper we present new data on deaf children’s receptive and expressive vocabulary knowledge in BSL from a group of deaf children aged 4-17 years with different language

FRSs should note that recording of risk assessment alone will not reduce risks, particularly if risk assessment is seen as the solution to all occupational health and safety

It was observed that the maximum microleakage was seen in Group B (Glass Ionomer cement type VII) followed by group C (Compomer) and least in group A

Soybean plants treated with 100% chemical fertilizer NPK were colonized by the highest aphid numbers (130.00 aphids per plant), and this density was significantly

Directors' Laboratory Accreditation Board ("ASCLD/LAB"), the entity that accredits the Laboratory, and the record ofNYPD's response to issues relating to Liota's

When using an Interaction Server Cluster with Genesys desktop applications such as Workspace Desktop Edition, you may use an N+1 architecture, where each Interaction Server