• No results found

BST thin films

Structural and electrical behavior of tin doped ba0 6sr0 4tio3 thin films

Structural and electrical behavior of tin doped ba0 6sr0 4tio3 thin films

... (BST) thin films have attracted attention for their potential application in ferroelectric microbolometers as UFPA due to their high dielectric constant, low loss tangent and high breakdown strength ...

8

Influence Of Ga Doping On The Structural, Optical And Electrical Properties Of Ba0.6Sr0.4tio3 Thin Films

Influence Of Ga Doping On The Structural, Optical And Electrical Properties Of Ba0.6Sr0.4tio3 Thin Films

... The films preheated at 400ºC and annealed at 800ºC may be responsible for the increase in lattice ...doped BST thin films were clearly observed as the 2θ peak shifted toward lower angle in ...

6

Sputtered (Bax, Sr1-x)TiO3, BST, Thin Films on Flexible Copper Foils for Use as a Non-Linear Dielectric

Sputtered (Bax, Sr1-x)TiO3, BST, Thin Films on Flexible Copper Foils for Use as a Non-Linear Dielectric

... titanate, BST, thin films deposited on copper ...from BST/Cu specimens and dielectric properties are compared to microstructure found through physical ...Ferroelectric thin films ...

260

Nanoindentation of GaSe thin films

Nanoindentation of GaSe thin films

... GaSe thin films were deposited on the ...GaSe films was about 200 ...GaSe films were inspected by X-ray diffraction (XRD; Bruker D8 Advance TXS with Cu-Kα radiation, λ = ...GaSe thin ...

6

Manufacture, Applications, and Opportunities of Thin Film Palladium-Silver (PdAg) Alloys: A Review

Manufacture, Applications, and Opportunities of Thin Film Palladium-Silver (PdAg) Alloys: A Review

... PdAg thin films can be prepared using traditional physical methods such as cold rolling, or more modern and controllable chemical or physical deposition techniques such as electrodeposition or chemical ...

18

Characterization of cdxse1-xs/pbs thin films deposited by chemical bath deposition for p-n junction solar cell application

Characterization of cdxse1-xs/pbs thin films deposited by chemical bath deposition for p-n junction solar cell application

... in thin films. A semiconductor material is said to be in thin film form only when it is built up as a thin layer on a substrate by a controlled condensation of the individual atomic, ...

101

Composition and crystalline properties of TiNi thin films prepared by pulsed laser deposition under vacuum and in ambient Ar gas

Composition and crystalline properties of TiNi thin films prepared by pulsed laser deposition under vacuum and in ambient Ar gas

... TiNi thin films, the TiNi films were fabricated by PLD method under vacuum (5 × 10 -6 Torr) and in 200- mTorr Ar ...deposited films were charac- terized by EDXS, a surface profiler, and XRD at ...

6

Structural and Optical Properties of Hydrothermally Grown Zns Thin Films

Structural and Optical Properties of Hydrothermally Grown Zns Thin Films

... ZnS films were prepared using dip coating method. The Zinc Sulphate solution was prepared by adding Zinc Sulphate (ZnSO4.7H2O) with the de-ionized water and this mixture was stirred with magnet for 20 minutes. ...

5

Study Of Electrical And Optical Properties Of Thin Films

Study Of Electrical And Optical Properties Of Thin Films

... the films could be repeated ...the films that thus delivered the most minimal ever sheet opposition esteems revealed for the doped SnO 2 films from SnCl2 ...

14

Volume 9 | Issue 3 - 2019

Volume 9 | Issue 3 - 2019

... solution was sprayed on preheated substrates. Substrates were heated to 350 ºC by using an electrical heater. When the solution was sprayed, the following reaction takes place at the surface of the heated substrate. The ...

6

Fabrication and characterization of antibacterial surfaces derived from geranium essential oil using PECVD

Fabrication and characterization of antibacterial surfaces derived from geranium essential oil using PECVD

... polymerized films demonstrated a wide range of functional groups in their structure, such as primarily methyl/methylene functionalities as well as hydroxyl, alkene and carbonyl ...polymer films have the ...

165

Preparation and Characterization of La0 67–x Li3x TiO3 Solid State Electrolyte Used for Electrochromic Mirrors

Preparation and Characterization of La0 67–x Li3x TiO3 Solid State Electrolyte Used for Electrochromic Mirrors

... LLTO thin films have slightly yellow color in visible ...of thin films is high in visible range, it is of 80% to ...the films prepared by electron beam deposition from the LLTO targets ...

8

DEVELOPMENT OF PVDF THIN FILMS

DEVELOPMENT OF PVDF THIN FILMS

... coated films at initial and grey prediction parameters were characterized to found the β -phase content, and it was found out that the β-phase was highest in the film produced by grey prediction ...

12

Oral thin films: an overview

Oral thin films: an overview

... oral thin film product to incorporate a drug and were introduced in the United States in September, 2003 by Prestige Brands international for relief of sore ...These films typically contain water soluble ...

29

Novel Pre oxidation Patterning on Thin Aluminium Film Generating Ordered Nanopores through Anodization

Novel Pre oxidation Patterning on Thin Aluminium Film Generating Ordered Nanopores through Anodization

... aluminium substrate. Distortions of the tungsten layer on entry into the film and retention of tungsten species in the film are compatible with porosity arising mainly from flow of anodic oxide beneath the pore base ...

10

Indium Doped Zinc Oxide Thin Films: Effect on Structural, Optical and Electrical Characteristics

Indium Doped Zinc Oxide Thin Films: Effect on Structural, Optical and Electrical Characteristics

... Figure 1 shows the SEM micrograph of both undoped and doped IZO films with 11.0kx magnification. Undoped films have smooth, closely packed grains which are uniformly distributed. When Indium (1%) was ...

5

Design and Characterization of Frequency Agile RF and Microwave Devices using Ferroelectrics

Design and Characterization of Frequency Agile RF and Microwave Devices using Ferroelectrics

... RF sputtering is by far the most commonly used method for BST thin-film growth. Various groups have reported varactors and devices using this versatile technique. It is a physical vapor deposition process ...

306

1.
													Structural and electrical properties of   sns thin films via   chemical bath deposition technique

1. Structural and electrical properties of sns thin films via chemical bath deposition technique

... sulphide films were deposited on microscope slide from bath solution which contains stannous chloride, glacial acetic acid, tri-ethanol amine and ...deposition films on the optical microscope ...the ...

10

Effects of PBr3 Addition to Polysilane Thin Films on Structures and Photovoltaic Properties

Effects of PBr3 Addition to Polysilane Thin Films on Structures and Photovoltaic Properties

... Organic thin film solar cells are potential next generation solar ...Polysilane thin films were spin-coated from solutions containing phosphorus (P), and the ef- fects of P addition on film ...

15

Volume 8 | Issue 4 - 2018

Volume 8 | Issue 4 - 2018

... the increased thickness. The experimental d-values for high peak and ASTM d value (3.505 Å) were in good agreement and indicated the creation of a hexagonal (wurtzite) structure. The special orientation of CdSe was found ...

7

Show all 7785 documents...

Related subjects