• No results found

cold-deformed carbon steel

Effect of Soaking Time on the Mechanical Properties of Annealed Cold Drawn Low Carbon Steel

Effect of Soaking Time on the Mechanical Properties of Annealed Cold Drawn Low Carbon Steel

... a cold working ...from cold working of the metal becomes unstable due to the strain hardening ...such deformed structure is anisotropy of mechanical ...in cold worked metals ...

6

Microstructures and Mechanical Properties of Ultra Low Carbon Interstitial Free Steel Severely Deformed by a Multi Stack Accumulative Roll Bonding Process

Microstructures and Mechanical Properties of Ultra Low Carbon Interstitial Free Steel Severely Deformed by a Multi Stack Accumulative Roll Bonding Process

... IF steel before and after six-layer stack ARB ...was deformed by 50% cold rolling, as shown in ...IF steel processed by two-layer stack ARB at ambient ...

5

Brittle Ductile Transition in Low Carbon Steel Deformed by the Accumulative Roll Bonding Process

Brittle Ductile Transition in Low Carbon Steel Deformed by the Accumulative Roll Bonding Process

... low carbon steel demonstrates rather high ductility, a small amount of phosphorus was added to reduce its ductility and to demonstrate the remarkable effect of grain refining on its fracture toughness at low ...

8

Influence of Degree of Cold Drawing on the Mechanical Properties of Low Carbon Steel

Influence of Degree of Cold Drawing on the Mechanical Properties of Low Carbon Steel

... The strain hardening, also known as work hardening, which results from the wire drawing process, is an in- crement in internal energy associated with an increase in the dislocation density as well as the density of point ...

8

Recrystallization Kinetics and Microstructure Evolution of Annealed Cold Drawn Low Carbon Steel

Recrystallization Kinetics and Microstructure Evolution of Annealed Cold Drawn Low Carbon Steel

... 25% cold-drawn low-carbon steel and as annealed at 650˚C for annealing time range of 5 - 20 ...the cold-drawn steel shown in Figure 1(a) non-treated is inhomogeneous with accumulating ...

7

An Experimentalstudy On Concrete Filled Tubular Columns Using Varying Steel Materials

An Experimentalstudy On Concrete Filled Tubular Columns Using Varying Steel Materials

... varying steel materials under axial ...stainless steel, 4 No’s is of Mild steel and 4 No’s is of cold formed steel were tested under axial ...Varying steel materials are ...

6

Experimental and analytical investigation torsional behavior of sigma profile

Experimental and analytical investigation torsional behavior of sigma profile

... on cold-formed thin-walled steel members in steel construction industry compare to timber and concrete application is because of the several advantages that offered by the cold-formed ...

24

Very Fine Structured DP Steel with Tempered Martensite Matrix Fabricated by Fast Heating

Very Fine Structured DP Steel with Tempered Martensite Matrix Fabricated by Fast Heating

... low carbon chromium-molybdenum steel with chemical composition listed in Table 1 was used in this study, which is classified as SCM415 in Japan Industrial Standard ...This steel was through ...

6

Metal Properties, Characteristics Uses, & Codes   US Army Course OD 1643 pdf

Metal Properties, Characteristics Uses, & Codes US Army Course OD 1643 pdf

... as carbon is present in various quantities rapid burning occurs, resulting in the bursting of the carbon ...varied carbon content, the various forms of iron and steel produce sparks that vary ...

98

Effect of Heat Treatment on Wear Rate of Different
Agricultural Grade Steels and Associated Cost Economics

Effect of Heat Treatment on Wear Rate of Different Agricultural Grade Steels and Associated Cost Economics

... All the surface treatment processes like hard facing and shot peening improve the surface properties of the components as the effected surface is worn out. The component starts behaving like untreated component and ...

6

Evaluation of applicability of thick E500 TMCP and F500W QT steel plates for Arctic service

Evaluation of applicability of thick E500 TMCP and F500W QT steel plates for Arctic service

... metal cold-resistant tests: Charpy V-notch impact test Cold resistance of the steel or welded joints is a key factor to guarantee robust steel performance at low temperatures and avoid failure ...

15

Experimental and Analytical Study on Bond Performance of Reinforced Bars Embedded in Fibre Reinforced Concrete

Experimental and Analytical Study on Bond Performance of Reinforced Bars Embedded in Fibre Reinforced Concrete

... The pullout specimens were prepared as per IS 516-1959 (reaffirmed 2004) [10]. The specimen consists of concrete cubes 150x150x150mm with a single reinforcing bar (16mm or 20mm dia) embedded vertically along the central ...

11

Suitability of technical materials for machinery subsoilers for soil tillage

Suitability of technical materials for machinery subsoilers for soil tillage

... tool steel was thermally processed in two modes: quenching and tempering on the value of 300 °C and 600 ...The steel tempered at 300 °C reaches about ...

8

Note to: Ms Melinda Bills, SPP Washington; Subject: South African sanctions, 17 September 1986

Note to: Ms Melinda Bills, SPP Washington; Subject: South African sanctions, 17 September 1986

... Angles, shapes and sections, of iron or steel, hot-rolled, forged, extruded, cold-formed or cold-finished; sheet piling of iron or steel, whether or not drilled, punched or made from ass[r] ...

16

Recrystallization Behavior and Texture Formation of Rapidly Annealed Cold Rolled Extralow Carbon Steel Sheets

Recrystallization Behavior and Texture Formation of Rapidly Annealed Cold Rolled Extralow Carbon Steel Sheets

... as carbon in solution and as cementites before annealing, while N exists in the form of precipitates of AlN and as N in ...of carbon is less than the equilibrium C in solution at the lower coiling ...

7

Highly Efficient Corrosion Inhibition of Carbon Steel in Aggressive Acidic Media with a Pyridazinium-based Ionic Liquid

Highly Efficient Corrosion Inhibition of Carbon Steel in Aggressive Acidic Media with a Pyridazinium-based Ionic Liquid

... The carbon steel specimens were electrochemically cleaned, then degreased and polished to a mirror-like ...the carbon steel specimen was washed with a copious amount of distilled water then ...

17

Microstructure of heavily deformed magnesium lithium composites containing steel fibers

Microstructure of heavily deformed magnesium lithium composites containing steel fibers

... infiltrating steel wool (iron) fibers with a molten magnesium-base matrix alloy (Ref 13) were exam- ...the steel (iron) fibers used in the prepa- ration of the magnesium-base composite materials was ad- ...

12

An Investigation Of Defects On Butt Joint Of Different Welding Technique Using Ultrasonic Method

An Investigation Of Defects On Butt Joint Of Different Welding Technique Using Ultrasonic Method

... low carbon steel, the carbon contain were less than ...Low carbon steel microstructure consists of ferrite and pearlite ...low carbon steel gave the low carbon ...

24

Micro-scale strain distribution in hot-worked duplex stainless steel

Micro-scale strain distribution in hot-worked duplex stainless steel

... stainless steel plate was prepared to be deformed at high temperature, following the procedure of the plane strain compression (PSC) test modified by Pinna et ...

7

The Structural Behaviour of Concrete Filled Steel Tubular columns

The Structural Behaviour of Concrete Filled Steel Tubular columns

... formed steel sections offer flexibility and versatility in producing a variety of cross section shapes, which are obtained by bending relatively thin metal sheets using either a cold rolling or a press ...

7

Show all 10000 documents...

Related subjects