• No results found

collector current

585-033-1_ZVM-122_123_Video_Monitors_Service_Manual_1983.pdf

585-033-1_ZVM-122_123_Video_Monitors_Service_Manual_1983.pdf

... This collector current is fed to the emitter of Q201, which increases the collector voltage of the video output transistor.. In- creasing the collector voltage decreas[r] ...

35

Switching Parameters Characterization of Aged IGBTs by Thermo-Electrical Overstress

Switching Parameters Characterization of Aged IGBTs by Thermo-Electrical Overstress

... “residual current” during turn ...“residual current” increases in ...“residual current” is large enough to cause the on-set of the DUT ’s ...the collector current increases abruptly ...

7

Electrical Parameters Characterization of Aged IGBTs by Thermo-Electrical Overstress

Electrical Parameters Characterization of Aged IGBTs by Thermo-Electrical Overstress

... larger current density than the power MOSFET, while the forward voltage drop is reduced ...gradual collector current ...“holes current” through the p -type region. This current flow ...

7

High Frequency Behavior of High Power IGBT Modules

High Frequency Behavior of High Power IGBT Modules

... The proposed model allows us to reproduce both the transient and frequency IGBT module behaviour. Figure 8 shows the PSpice simulated output voltage and the respective zoom at f=1MHz and Vin=25mVpp, input signal. The ...

7

Log and AntiLog Amplifiers. Recommended Text: Pallas-Areny, R. & Webster, J.G., Analog Signal Processing, Wiley (1999) pp

Log and AntiLog Amplifiers. Recommended Text: Pallas-Areny, R. & Webster, J.G., Analog Signal Processing, Wiley (1999) pp

... Most logarithmic amplifiers are based on the inherent logarithmic relationship between the collector current, Ic , and the base-emitter voltage, v be , in silicon bipolar transistors.[r] ...

32

Tatung_CM-149X_Series_Monitors_Service.pdf

Tatung_CM-149X_Series_Monitors_Service.pdf

... The overload identification limits in conjunction with collector current simulator Pin 4 the operating range of the control amplifier The collctor current is sImul[r] ...

45

Research on the protection coordination of permanent magnet synchronous generator based wind farms with low voltage ride through capability

Research on the protection coordination of permanent magnet synchronous generator based wind farms with low voltage ride through capability

... fault current with little emphasis on fault characteristics of wind turbines (especially PMSG) with LVRT ...circuit current for doubly-fed induct generator (DFIG) are derived without considering the effect ...

9

PHYSICO-TECHNOLOGICAL ASPECTS OF WORK OF LUBRICANT FILMS IN THE TRIBOSYSTEM "OVERHEAD LINE – CURRENT COLLECTOR CONTACT STRIP"

PHYSICO-TECHNOLOGICAL ASPECTS OF WORK OF LUBRICANT FILMS IN THE TRIBOSYSTEM "OVERHEAD LINE – CURRENT COLLECTOR CONTACT STRIP"

... – current collector contact strip» (OLCCCS) and identification of the features of such ...– current collector contact ...– current collector contact strip» during the operation ...

9

A Mathematical Model of Indirect Solar Drying of Dairy Products (Jameed)

A Mathematical Model of Indirect Solar Drying of Dairy Products (Jameed)

... the collector for preheating the air and the drying chamber are covered with nine glass ...absorber collector made of a glass cover and black absorber plate was inclined at angle of about 20 degree to the ...

13

Free Standing Selenium Impregnated Carbonized Leaf Cathodes for High Performance Sodium Selenium Batteries

Free Standing Selenium Impregnated Carbonized Leaf Cathodes for High Performance Sodium Selenium Batteries

... and current collector-free cathode, exhibiting an excellent rate capability and a high reversible specific capacity of 520 mA h g − 1 at 100 mA g − 1 after 120 cycles and 300 mA h g − 1 even at 2 A g − 1 ...

11

A REVIEW OF FLAT PLATE COLLECTOR AND MODIFIED FLAT PLATE COLLECTOR

A REVIEW OF FLAT PLATE COLLECTOR AND MODIFIED FLAT PLATE COLLECTOR

... [12] V.K.Goel et all studied the reverse flat-plate collector is a non-concentrating collector. It can collect solar heat at high temperatures which cannot be achieved by conventional non- concentrating ...

6

The Optimization of a Solar Collector of the Flat-Thin Box Type with a Fixed Reflector

The Optimization of a Solar Collector of the Flat-Thin Box Type with a Fixed Reflector

... high temperature of the working fluid is necessary for the absorption-refrigeration cycle. By taking an opti- mal dimension ratio for the collector-reflector design it is possible to get 33% to 38% more direct ...

8

High-rate-capability Graphene Oxide/Li4Ti5O12-composite Anode for Lithium-Ion Batteries

High-rate-capability Graphene Oxide/Li4Ti5O12-composite Anode for Lithium-Ion Batteries

... EIS is considered to be one of the most sensitive tools for studying changes in electrode behavior. The results of EIS measurements at the stable voltage of 1.55 V are shown in Fig. 8 for all samples. The impedance ...

14

Deliverable A Design guidelines for Solar Cooling of buildings

Deliverable A Design guidelines for Solar Cooling of buildings

... If the collector field is located far away from the machine room making costs for collector fluid unrealistically high, a flat plate heat exchanger close to the collector field can isol[r] ...

21

Experimentation of a Plane Solar Integrated Collector Storage Water Heater

Experimentation of a Plane Solar Integrated Collector Storage Water Heater

... standard collector with plane integrated storage can be sufficient considering the strong value of fraction of ...storage collector solar water heater since 1990 meets this need well, more especially as it ...

10

Production and Characterization of Micro-Tubular Solid Oxide Fuel Cells

Production and Characterization of Micro-Tubular Solid Oxide Fuel Cells

... the current cermets is relevant not only for the cell performance but also for long term operation where agglomeration or coarsening of Ni particles is particularly dentrimental as source of fracture for the ...

203

A comparison between electrochemical impedance spectroscopy and incremental capacity differential voltage as Li ion diagnostic techniques to identify and quantify the effects of degradation modes within battery management systems

A comparison between electrochemical impedance spectroscopy and incremental capacity differential voltage as Li ion diagnostic techniques to identify and quantify the effects of degradation modes within battery management systems

... From a review of the published literature the authors have identi fi ed that two suitable techniques to identify and quantify the effects of DMs are EIS [8,15] and IC-DV [2,4] because they can infer the effects of the ...

19

Numerical simulation and testing of a passive thermal solar collector on okra (hibiscus esculentus)

Numerical simulation and testing of a passive thermal solar collector on okra (hibiscus esculentus)

... A flat plate collector, passive solar dryer with dimension 0.8m x 0.6m x 0.4m has been design and constructed with locally available materials such as plywood, aluminum surfaced roofing sheet lined on the inside, ...

7

Selective liberation in dry milled spent lithium ion batteries

Selective liberation in dry milled spent lithium ion batteries

... aluminium current collector by its respective active materials may help in preventing breakage during mechanical ...copper current collector as compared to the aluminium current ...

32

Task 49/IV. Solar. Solar Process Heat for Production and Advanced Applications

Task 49/IV. Solar. Solar Process Heat for Production and Advanced Applications

... Type of solar thermal collector flat plate collector Klicken Sie hier, um Text einzugeben. Installed collector area [m²] Klicken Sie hier, um Text einzugeben[r] ...

14

Show all 10000 documents...

Related subjects