• No results found

critical thermal maximum

The critical thermal maximum of juvenile Spot. Leisotomus xanthurus, Lacepede

The critical thermal maximum of juvenile Spot. Leisotomus xanthurus, Lacepede

... field situations, these data indicate that a 10 C increase in cooling water temperature of a power generating stat.ion need not be lethal during spring migration of post-larval spot pr[r] ...

49

Oxygen dependence of upper thermal limits in fishes

Oxygen dependence of upper thermal limits in fishes

... upper thermal limits of fishes and other water- breathing ...upper thermal niche boundaries of these animals are expected to be highly sensitive to aquatic hypoxia and other environmental stressors that ...

8

Selection for upper thermal tolerance in rainbow trout (Oncorhynchus mykiss Walbaum)

Selection for upper thermal tolerance in rainbow trout (Oncorhynchus mykiss Walbaum)

... selection-driven bottleneck in the past. Phenotypically, the PFRC H-strain has been shown to tolerate the extreme temperature of 27°C for twice as long as the wild-type S-strain from Serpentine Dam (Molony et al., 2004). ...

10

Reduced carbon cycle resilience across the Palaeocene–Eocene Thermal Maximum

Reduced carbon cycle resilience across the Palaeocene–Eocene Thermal Maximum

... bance and return to its reference state; Grimm and Wissel, 1997; Holling, 1973; Scheffer et al., 2001), may be detectable prior to some abrupt climate transitions in the palaeorecord (Dakos et al., 2008; Lenton, 2011), ...

13

Productivity response of calcareous nannoplankton to Eocene Thermal Maximum 2 (ETM2)

Productivity response of calcareous nannoplankton to Eocene Thermal Maximum 2 (ETM2)

... The amplitude of change in Sr/Ca measured in the dominant genera Coccolithus and Toweius show considerable varia- tions at the Walvis Ridge both during ETM2 and over the 200 ka interval prior to and following ETM2. This ...

17

Productivity feedback did not terminate the Paleocene-Eocene Thermal Maximum (PETM)

Productivity feedback did not terminate the Paleocene-Eocene Thermal Maximum (PETM)

... Paleocene-Eocene Thermal Maximum (PETM) occurred approximately 55 million years ago, and is one of the most dramatic abrupt global warming events in the geological ...

8

An assessment of the efficiency of utilizing complex modifiers for 
		softening the liquid glass mixtures
		to improve iron and steel casting

An assessment of the efficiency of utilizing complex modifiers for softening the liquid glass mixtures to improve iron and steel casting

... that thermal distortion processes take place at temperatures ranging from 300-350°C; it produces water vapor, carbon dioxide, and ...low-temperature maximum, softening is achieved by the products of ...

5

Trends in Cardiac Pacemaker Batteries

Trends in Cardiac Pacemaker Batteries

... Critical factors in selecting a cardiac pacemaker battery technology are: minimum and maximum voltage, initial, average, and maximum discharge current, cont[r] ...

12

Numerical Investigation of Thermal Energy Storage Panel using Nanoparticle Enhanced Phase Change Material for Micro Satellites

Numerical Investigation of Thermal Energy Storage Panel using Nanoparticle Enhanced Phase Change Material for Micro Satellites

... for thermal storage using multiple PCMs was first proposed by them for power generation in space-based activities by ...overall thermal efficiency could theoretically be doubled, or even tripled by use of ...

6

Thermal response to cold in buildings with green covers  for tropical climate; green facades and green roofs

Thermal response to cold in buildings with green covers for tropical climate; green facades and green roofs

... Automatic measuring. Each of the prototypes contained 15 T- type 2x24 WG internal thermocouples, which are characterized as very precise instruments that can measure temperature with an error of ± 0.1-0.2°C (KINZIE, ...

8

Performance Investigation of 405 Stainless Steel Thermosyphon using Cerium (IV) Oxide Nano Fluid

Performance Investigation of 405 Stainless Steel Thermosyphon using Cerium (IV) Oxide Nano Fluid

... viscosity was studied by Sundar et al. with volume concentration range of 0.01–2.0% and the temperature range of 20–60°C. They observed that the viscosity of the nanofluid increased with an increase in the particle ...

7

Critical Limit Principle of Maximum Entropy and Reinterpretation of Scaling Laws

Critical Limit Principle of Maximum Entropy and Reinterpretation of Scaling Laws

... DOI: 10.4236/jmp.2018.911128 2036 Journal of Modern Physics to study certain objects with complexity. On the contrary, fractal geometry gets a simple result when using complicated self similar (SS) transformation. By ...

10

Failure Stress Energy Formula

Failure Stress Energy Formula

... and Thermal Control different phases ...and thermal conductivity of the material sintered at 1500˚C suffer definite de- crease which is reflected in R’ criterion, which is determining for material evalu- ...

17

Performance and Emission  of Emulsified Fuel in a low Speed Diesel Engine

Performance and Emission of Emulsified Fuel in a low Speed Diesel Engine

... Effect of water diesel emulsion in a slow speed water cooled four stroke diesel engine is studied. Emulsified fuel in the ratio of 5, 10, and 15 percent of water in diesel is prepared. Tween 80 and Span 80 are used as ...

6

Influence of the maximum temperature of the thermal cycle on the properties and structure of the HAZ of steel S700MC

Influence of the maximum temperature of the thermal cycle on the properties and structure of the HAZ of steel S700MC

... of thermal cycles consisted of resistive heating of samples prepared for the impact ...Single thermal cycles were simulated at temperatures ranging from 400 to 1300 ºC, 100 ºC and the cycle ...the ...

7

Fuel Managements for an Orgel Prototype Orientation Study  EUR 4204

Fuel Managements for an Orgel Prototype Orientation Study EUR 4204

... At fixed mean maximum cladding temperature of the fuel element and fixed maximum coolant entrance velocity, the thermal performances of the core will slightly change as to yield the ther[r] ...

42

Using Microwave Energy to Treat Tumors

Using Microwave Energy to Treat Tumors

... significant cell destruction. However, during the second phase blood flow decreases, which is most likely due to localized microthrombosis in the hottest places in the tissue, and the amount of tissue necrosis increases ...

27

Stress and Strain Analysis on Extruder Auger Assembly in Static Condition

Stress and Strain Analysis on Extruder Auger Assembly in Static Condition

... most critical component is an auger assembly so when the maximum load will apply on the auger assembly that time the maximum possibility of failure of this auger assembly by failing the auger face or ...

9

Last interglacial model–data mismatch of thermal maximum temperatures partially explained

Last interglacial model–data mismatch of thermal maximum temperatures partially explained

... LIG thermal maximum is difficult, because it is the temperature anomaly in combi- nation with spatial differences in the occurrence of the tem- perature anomalies within the LIG that determine the size of ...

12

Critical thermal limits affected differently by developmental and adult thermal fluctuations

Critical thermal limits affected differently by developmental and adult thermal fluctuations

... A thermal fluctuation cycle is depicted going from low temperature at night to high temperature during the day and back to low temperature the following ...(both critical minimum and critical ...

8

Show all 10000 documents...

Related subjects