• No results found

delay faults

Two Pattern Test Cubes for Transition Path Delay Faults Test for ISCAS-85 C432

Two Pattern Test Cubes for Transition Path Delay Faults Test for ISCAS-85 C432

... path delay faults, certain specified input values in a test cube are needed only for determining the lengths of the paths associated with detected ...Path delay faults, and therefore, small ...

7

A Non-Reversible Insertion Method for Hardware Trojans Based on Path Delay Faults

A Non-Reversible Insertion Method for Hardware Trojans Based on Path Delay Faults

... path delay HT (PDHT), was proposed at CHES 2016 ...the delay of a rarely sensitized path called rare path ...propagation delay along the RP is larger than the original clock period, and therefore a ...

18

Black Box Delay Fault Models for Non-scan Sequential Circuits

Black Box Delay Fault Models for Non-scan Sequential Circuits

... Functional delay fault models based on the primary inputs, primary outputs, and state variables of the circuit have been successfully used for test generation [2], [3], [4], [5], [6], ...Functional delay ...

20

ON THE ENRICHMENT OF FUNCTIONAL DELAY FAULT TESTS

ON THE ENRICHMENT OF FUNCTIONAL DELAY FAULT TESTS

... The following points can be seen from Tables 1-3. The procedure EoFDT was able in all cases to enrich the test pattern sets generated for detection of functional delay faults, i.e. for all circuits, in all ...

9

A NEW BIST ARCHITECTURE FOR TEST PER CLOCK AND TEST PER SCAN SCHEMES

A NEW BIST ARCHITECTURE FOR TEST PER CLOCK AND TEST PER SCAN SCHEMES

... Available Online at www.ijpret.com 237 the means to test for delay faults. PDF’s are classified, according to their testability, as singly- testable (ST) or non-ST. An ST PDF affects the circuit speed, and ...

9

Review of Built in Self Test Technique in Various Digital Circuit Applications

Review of Built in Self Test Technique in Various Digital Circuit Applications

... stuck-at faults and transition faults even if it is applied at high ...path-delay faults requires some additional modifications in the combinational ...

5

IoT Based Humidity and Temperature Monitoring Using Arduino UNO

IoT Based Humidity and Temperature Monitoring Using Arduino UNO

... Nidamanuri Sai Charan, Kakarla Hari Kishore "Reorganization of Delay Faults in Cluster Based FPGA Using BIST” Indian Journal of Science and Technology, ISSN No: 0974-6846, Vol No.9, Issu[r] ...

5

A new method for improving path delay fault coverage

A new method for improving path delay fault coverage

... of delay faults, raising and falling path delay faults ...their delay, no matter what the type of path delay fault ...path delay fault model can show the actual fault more ...

8

Internal Fault Detection, Location, and Classification in Stator Winding of the Synchronous Generators Based on the Terminal Voltage Waveform

Internal Fault Detection, Location, and Classification in Stator Winding of the Synchronous Generators Based on the Terminal Voltage Waveform

... TTF or PGF will occur due to a damage to the insulation between the adjacent bars or between a bar and the stator core, respectively. The current through the faulty point to the ground in PGFs can be sensed by a ...

10

008858 00 Programming With General System Calls Mar86 pdf

008858 00 Programming With General System Calls Mar86 pdf

... Summary of Insert Files Summary of Faults Synchronous Program Faults Synchronous System Faults Types of Fault Handlers Severity Levels Default Streams lOS Calls to Manipulate Stream Conn[r] ...

475

A  Practical  Second-Order  Fault  Attack  against  a  Real-World  Pairing  Implementation

A Practical Second-Order Fault Attack against a Real-World Pairing Implementation

... Previous results on fault attacks against pairing computations have two drawbacks. None of the proposed attacks against PBC have been practically evaluated on a real pairing implementation to date. Furthermore, the ...

16

Classifying Faults Locations in Cable Terminations and Investigation of the Faults Reasons

Classifying Faults Locations in Cable Terminations and Investigation of the Faults Reasons

... Abstract: Cable termination faults are problematic in electrical networks almost always. Technology has solved problems somewhat, but there are many annual reports about damaged cable terminations. For analyzing ...

8

FAULT MODELING AND TEST GENERATION FOR QUANTUM DOT CELLULAR AUTOMATA DESIGNS

FAULT MODELING AND TEST GENERATION FOR QUANTUM DOT CELLULAR AUTOMATA DESIGNS

... An extra cell in a majority gate cause the polarization value degradation faults. The QCA layouts of majority gates with an extra cell in four corners of center cell in majority are shown in Figures 10(a) to 10(d) ...

9

Repair Analysis for Embedded Memories Using Block-Based Redundancy Architecture

Repair Analysis for Embedded Memories Using Block-Based Redundancy Architecture

... Abstract— Capacity and density of embedded memories have rapidly increased therefore they have higher probability of faults. As a result, yield of system-on-a-chip designs with embedded memories drops. Built-in ...

5

Induction Motor Fault Diagnostics using Fuzzy System

Induction Motor Fault Diagnostics using Fuzzy System

... the faults, combinations of faults and their limits of slip to which the system responds ...the faults simulator and tabulated in Table No ...

5

Detection of software faults

Detection of software faults

... between faults and code ...count faults in an accurate and repeatable manner, just as we would expect to enumerate statements, lines of code and so ...about faults at the same ...

16

Generating Fault Tolerance Mechanism in Cloud Computing System using EDP   PART 2

Generating Fault Tolerance Mechanism in Cloud Computing System using EDP PART 2

... Abstract: With the high usage of cloud computing, fault tolerance is a major concern. Some of the errors due to faults make the service and server unavailability. The fault tolerance technique ensures that to ...

8

Effect of Faults on Kalman Filter of State Vectors in Linear Systems

Effect of Faults on Kalman Filter of State Vectors in Linear Systems

... sensor faults and control input anomalies are simulated respectively, compared with the normal estimation value of state vectors, the estimation deviation are obtained, and draw three component change curves to ...

12

FFT analysis of ball bearing faults using AE

FFT analysis of ball bearing faults using AE

... bearing faults in rotating machines plays an important role in industrial plants since it avoids the occurrences of serious failure in many parts of the machinery that causes plant ...

6

The tectonic characteristics and evolution in Gulongnan region of Songliao basin

The tectonic characteristics and evolution in Gulongnan region of Songliao basin

... two faults (type T11 - T1 or T11); Qingshankou group –Nenjiang segment one and segment two faults (type T2 - T1) ; less number of Yaojia group - phase retrograde at the end of Nenjiang group faults ...

6

Show all 6955 documents...

Related subjects