• No results found

fatigue crack propagation curve

Physically short crack propagation in metals during high cycle fatigue

Physically short crack propagation in metals during high cycle fatigue

... short crack experiences a retardation but does not ...K(a) curve almost collapses on the resistance curve, and then the pre- dicted propagation is very high, due to the strong retardation at ...

23

38CrSi Corrosive Fatigue Crack Propagation Model by Various Polarization Potentials

38CrSi Corrosive Fatigue Crack Propagation Model by Various Polarization Potentials

... polarization curve of 38CrSi steel in ...polarization curve, which was controlled by metallic anode ...polarization curve, which was controlled by oxygen ...steel fatigue crack ...

7

Effects of oxygen related damage on dwell fatigue crack propagation in a P/M Ni based superalloy : from 2D to 3D assessment

Effects of oxygen related damage on dwell fatigue crack propagation in a P/M Ni based superalloy : from 2D to 3D assessment

... the crack was allowed to propagate under a fixed loading amplitude. Crack length was monitored and recorded by a DCPD method using 4 probe ...the curve of the variation in the electrical potential ...

27

THERMAL STRESSES AND FATIGUE CRACK PROPAGATION ANALYSIS OF BOILER STEAM DRUM

THERMAL STRESSES AND FATIGUE CRACK PROPAGATION ANALYSIS OF BOILER STEAM DRUM

... potential fatigue crack initiation sites including the weld root, by using the structural hot spot stress on the surface as an indication of that in the region of ...SN Curve or the stress ...

19

Simulation of Railroad Crack Growth Life under the Influence of Combination of Mechanical Contact and Thermal Loads

Simulation of Railroad Crack Growth Life under the Influence of Combination of Mechanical Contact and Thermal Loads

... multi-axial fatigue problem as a uniaxial fatigue ...axial fatigue model proposed by Dang Van et al [14] to present a fatigue life prediction model for rolling contact fatigue problem ...

10

Effect Of Wave Modulation Measured At Various Locations For Damage Detection Using Vibro-Acoustic Method

Effect Of Wave Modulation Measured At Various Locations For Damage Detection Using Vibro-Acoustic Method

... detect fatigue crack in ...of fatigue failure development from the initiation of micro crack up to the fracture of the ...material. Crack formation is then classified into 3 modes where ...

24

Effect of Thermal Cycles on the Fatigue Life of AISI 321  Stainless Steel

Effect of Thermal Cycles on the Fatigue Life of AISI 321 Stainless Steel

... thermal fatigue cracks in AISI 321 steel subjected to repeated thermal shocks was ...rapid crack initiation of tested ...engineering crack 0.5 mm long. The most of standard lifetime curves for ...

8

High Cycle Fatigue Property and Micro Crack Propagation Behavior in Extruded AZ31 Magnesium Alloys

High Cycle Fatigue Property and Micro Crack Propagation Behavior in Extruded AZ31 Magnesium Alloys

... the crack tip. Figure 9 shows schematic drawing of the crack propaga- tion paths and the plastic zone ...the crack tip doesn’t occur, then the crack propagates to the grain ...the crack ...

6

Effects of ultrasonic impact treatment on fatigue life of pre exfoliated AA 2024 t351

Effects of ultrasonic impact treatment on fatigue life of pre exfoliated AA 2024 t351

... increased crack growth ...induced crack growth rates of an order 2 - 1 5 times that of air ...higher crack growth rates, but here they demonstrated the effect was also evident during short ...

201

Comprehensive Comparisons of Two and Three Dimensional Numerical Estimation of Stress Intensity Factors and Crack propagation in Linear Elastic Analysis

Comprehensive Comparisons of Two and Three Dimensional Numerical Estimation of Stress Intensity Factors and Crack propagation in Linear Elastic Analysis

... two-dimensional crack growth simulation program developed as source code by using Visual Fortran Language whereas the second is ANSYS mechanical program (3D structural analysis for fracture mechanic ...the ...

10

Three Dimensional Fatigue Propagation Modelling of a Nozzle Corner Crack

Three Dimensional Fatigue Propagation Modelling of a Nozzle Corner Crack

... for crack modelling have been noticeably improved for propagating ...initial crack is usually taken as a part of ellipse, and for such type of crack a special module has been developed in SYSTUS ...

16

Margin effect on crack propagation of cold-worked hole under fatigue loading

Margin effect on crack propagation of cold-worked hole under fatigue loading

... calculated fatigue propagation lives for non cold-worked hole plates are closed to the experimental results, as expected; the calculated lives is on the conservative side, within a factor of about ...the ...

5

The   Energetic Approach of Elastoplastic Fracture Mechanics Applied to the Problem   of Unloading

The Energetic Approach of Elastoplastic Fracture Mechanics Applied to the Problem of Unloading

... a crack propagates or not in an elastic medium relies on Griffith’s criterion, see ...continuous crack growth and cannot be used to predict crack initiation in a non-craked medium and discontinuous ...

8

Effects of oxidation on fatigue crack initiation and propagation in an advanced disc alloy

Effects of oxidation on fatigue crack initiation and propagation in an advanced disc alloy

... evaluate crack evolution. Formation of oxides during fatigue test was assessed by SEM, energy dispersive X-ray spectrometry (EDS) and electron backscatter diffraction ...

8

INFLUENCE OF MICROSTRUCTURE ON THE PROPAGATION OF FATIGUE CRACKS IN INCONEL 617

INFLUENCE OF MICROSTRUCTURE ON THE PROPAGATION OF FATIGUE CRACKS IN INCONEL 617

... molybdenum-rich within the matrix [3]. The alloy is typically purchased in the solution annealed condition, although precipitation of carbides can occur during service [6]. High temperature corrosion is combated by the ...

95

High cycle fatigue and fatigue crack propagation behaviors of β-annealed Ti-6Al-4V alloy

High cycle fatigue and fatigue crack propagation behaviors of β-annealed Ti-6Al-4V alloy

... S-N fatigue specimen, and (c) CT specimen used in this ...S-N fatigue tests were conducted on a servo-hydraulic testing machine (model: Instron 8516) with the applied stresses ranging between 170 and 405 ...

10

Study of Crack Propagation in a Multicracked Structure  in Thermal Fatigue (D210)

Study of Crack Propagation in a Multicracked Structure in Thermal Fatigue (D210)

... modeling crack propagation by numerical ...discrete crack propagation is, the requirement that the spatial discretisation accommodates the changing topology of the ...of crack advance ...

8

Environmentally Assisted Cracking Behavior of Dissimilar Metal Weldments under High Temperature Water Conditions

Environmentally Assisted Cracking Behavior of Dissimilar Metal Weldments under High Temperature Water Conditions

... studied. Fatigue and corrosion fatigue crack growth rates of the dissimilar metal weldments were observed to increase with crack extension under the nominally constant K loading ...the ...

8

Adaptive Finite Element Modeling of Fatigue Crack Propagation

Adaptive Finite Element Modeling of Fatigue Crack Propagation

... for fatigue crack propagation simulation under constant amplitude loading ...2D crack paths and surfaces as well as on the evaluation of components Lifetimes as a part of the damage tolerant ...

5

Accelerated Corrosion Fatigue Crack Growth Studies On Is 2062 Gr  E 300 Steel

Accelerated Corrosion Fatigue Crack Growth Studies On Is 2062 Gr E 300 Steel

... Corrosion fatigue crack growth experiments were carried out on two Eccentrically-Loaded Single Edge notch Tension [ESE(T)] specimens made of IS 2062 steel in salt water ...hydraulic fatigue rated ...

12

Show all 10000 documents...

Related subjects