• No results found

freq 1 to 40 GHz

DPA,  Bitslicing   and  Masking  at 1  GHz

DPA, Bitslicing and Masking at 1 GHz

... It is in this context that bitsliced implementations rise as an attractive al- ternative for AES in software. Originally proposed by Biham [7] to improve the performance of DES in software, the idea behind bitslicing ...

25

Characterization of Millimetre waveband at 40 GHz wireless channel

Characterization of Millimetre waveband at 40 GHz wireless channel

... 38-40 GHz, 60 GHz and more recently 70 and 80 GHz becomes an area of interest [1], but more specifically 40 GHz and 60 GHz Wireless Channel represents an attractive ...

5

A 28-40 GHz
 Doubly Balanced Monolithic Passive Mixer with a Compact IF Extraction

A 28-40 GHz Doubly Balanced Monolithic Passive Mixer with a Compact IF Extraction

... Figure 3 represents the measured and simulated conversion loss as a function of RF frequency for the down-converter mode. The star DBM is driven by an LO power of 13 dBm. The measurements were performed with a RF power ...

8

Development of a new approach for high-quality quadrupling frequency optical millimeter-wave signal generation without optical filter

Development of a new approach for high-quality quadrupling frequency optical millimeter-wave signal generation without optical filter

... 60 GHz millimeter-wave can be generated from a 15 GHz RF oscillator with an OSSR as high as 40 dB and an RFSSR exceeding 35 dB without any optical or electrical filter when the extinction ratio of ...

20

High Impedance Surfaces Based Antennas for High Data Rate Communications at 40 GHz

High Impedance Surfaces Based Antennas for High Data Rate Communications at 40 GHz

... of 40 GHz, the difference between the cases N = 2 and N = 3 is more important than that between N = 1 and N = 2 and that between N = 3 and N = ...

13

Implementation and analysis of 2 Tbps MDRZ DWDM system at ultra narrow channel spacing

Implementation and analysis of 2 Tbps MDRZ DWDM system at ultra narrow channel spacing

... rate 40 Gbps DWDM system is simulated with 50 GHz over a transmission distance of 1800 km using DRZ and MDRZ modulation formats and moreover the role of laser line-width is also investigate as it plays an ...

5

Low Frequency Behavior of CVD Graphene from DC to 40 GHz

Low Frequency Behavior of CVD Graphene from DC to 40 GHz

... After the chemical synthesis, a coplanar waveguide structure is deposited on the graphene sheet using “Process I” and “Process II” in Fig. 2(a). “Process I” includes three stages: (i) Standard lithography is applied to ...

7

Design A 3.5 Antenna For Dual Band Applications

Design A 3.5 Antenna For Dual Band Applications

... TITLE PAGE 3.1 Design Specification 34 3.2 The material and height for substrate, patch and ground 35 3.3 Value for 𝜆𝑔 in mm for frequency of 2.4 GHz 40 and 5.2 GHz 3.4 Dimension in mm o[r] ...

24

Modified Phasing Element for Broadband Reflectarray Antennas

Modified Phasing Element for Broadband Reflectarray Antennas

... Reflectarrays require at least 360 ◦ phasing range for the reflection of their elements at a given frequency of operation. This requirement is usually not obtained by typical microstrip phasing elements such as square ...

8

A Polarization-Dependent Mutiband Ram Design

A Polarization-Dependent Mutiband Ram Design

... (4.36 GHz and 9.75 GHz) for x-polarization (the electric field polarization is kept along the x-axis) and three resonances ...(3.85 GHz, 4.86 GHz and 7.39 GHz) for y-polarization (the ...

8

1 GHz Inverse Filters using Operational Amplifier

1 GHz Inverse Filters using Operational Amplifier

... The second order inverse band pass biquad filter depicted in the figure 5 designed for a centre frequency of 1 GHz by selecting R1 and R2 = 159.154 MΩ and C1 and C2 = 1 pF is simulated a[r] ...

7

Broadband Multipath-Rejection Shorted Annular Patch Antenna for GPS Applications

Broadband Multipath-Rejection Shorted Annular Patch Antenna for GPS Applications

... location of the pins father from the center, the impendence matching of the low frequency end has deteriorated. As a result, the bandwidth decreases to 0.425 GHz (1.175–1.6 GHz). By loading the shorted ...

8

Via-Hole Less Broadband Conductor-Backed Coplanar Waveguide to Coupled Microstrip Transition Up to 40 GHz

Via-Hole Less Broadband Conductor-Backed Coplanar Waveguide to Coupled Microstrip Transition Up to 40 GHz

... (bandwidth 40 GHz for a 500 µ m pitch and 30 µ m pad) and a CSR-4 calibration substrate from Cascade ...4.5 GHz to 39.5 GHz. The two resonant peaks at 20 and 40 GHz are caused by ...

5

New Technologies Driving Decade Bandwidth Radio Astronomy: Quad ridged Flared Horn and Compound Semiconductor LNAs

New Technologies Driving Decade Bandwidth Radio Astronomy: Quad ridged Flared Horn and Compound Semiconductor LNAs

... The first nine MMICs were wafer-probed at 300 K and their S-parameters are displayed in Figure 7.19 along with the expected performance per simulations. The most important observation is the large gain slope. The gain ...

182

Dividend (Vol  40, No  1, Spring, 2009)

Dividend (Vol 40, No 1, Spring, 2009)

... TAPPAN & HILL 5 Remembering William Davidson … Ross launches master’s degree in supply chain management … MBA essentials course offered to campus entrepreneurs … Ross partners with Shan[r] ...

68

Jesaja 40:1 2   Suiwer evangelie!

Jesaja 40:1 2 Suiwer evangelie!

... Jesaja 40:1-2 gaan om ‘troos’, om ‘opdragte van God’, en om ‘die vryskelding van skuld’, daar kan ek nóú ook sê dat die stuk oor twee stelle opdragte van God ...

16

Design of Broadband RoF PON for the Last Mile

Design of Broadband RoF PON for the Last Mile

... An increase in the demand of broadband service has encouraged research and study to find a solution to offer an ade- quate amount of service. Living in this digital world with downloading video, voice or data leads us ...

9

Contrast joints of glass-fibre with carbon-fibre reinforced low density polyethylene composite bonded by microwave irradiation

Contrast joints of glass-fibre with carbon-fibre reinforced low density polyethylene composite bonded by microwave irradiation

... The next thing worth discussing will be the lap shear strengths of the two materials obtained by processing them with VFMF. Both materials were bonded at a frequency range most suitable to process them (see Table ...

22

ECE-V-DIGITAL SIGNAL PROCESSING [10EC52]-NOTES.pdf

ECE-V-DIGITAL SIGNAL PROCESSING [10EC52]-NOTES.pdf

... Suppose the filter to be designed is Low pass filter then the convolution of ideal filter freq response and window function freq response results in distortion in the resultant filter freq response. ...

161

Volume 40 - Article 1 | Pages 1–26

Volume 40 - Article 1 | Pages 1–26

... following consequences: (a) they would stay young longer; (b) they would have a very close emotional relationship with their children; (c) their standing in their social network would increase; (d) their adult children ...

28

Show all 10000 documents...

Related subjects