Functional Coatings
Functional Coatings: Superhydrophopbic And Conductive Coatings
... these coatings can release low molecular weight silicone fluid that comes from the bulk of coating, surrounds contaminants and recover hydrophobicity (Cherney et al, ...rubber coatings for insulators, but ...
269
Facile Approach in Fabricating TiO2/organic Functional Coatings
... through a facile approach. Scanning electron microscopy, thermal analysis, contact angle analyzer and electrochemical tests were obtained to describe the coatings’ surface morphologies, optimum temperature, ...
11
Engineered Deposition of Functional Coatings from Micro- and Nanoparticles using Convective Assembly
... °C). Coatings were reproducibly flash heated by flaming (glass substrates only) or microwaving ranging from 10 seconds to 10 ...the coatings during ...
184
Functional Coatings Based on Denaturation and Adsorption of Proteins.
... several functional monomers including 2- hydroxyethyl methacrylate and ...protein coatings provided sufficient number of amine- and hydroxyl- groups on the surface, which allowed the attachment of atom ...
210
Deposition of nanoscale multilayer CrN/NbN physical vapor deposition coatings by high power impulse magnetron sputtering
... electroplated coatings, which provide a range of thin, hard, wear and corrosion resistant functional ...PVD coatings offer an excellent choice in replacing hard chrome and monolithic CrN ...
26
Technological and economic perspectives for development and manufacturing of cathode materials for lithium ion batteries for transport industry
... applying functional coatings on electrodes can be introduced into the manufacturing cycle of ...passivation coatings but also for other types of functional coatings, for example, the ...
7
Understanding and improving the degradation behaviour of magnesium-based biomaterials
... biphasic coatings at higher HA:TCP ratios (Yamada et ...HA/TCP coatings on Ti implants have already been utilised in a clinical setting, and have demonstrated improved biocompatibility and decreased bone ...
150
Plasma Electrolytic Oxidation (PEO) Coatings on an A356 Alloy for Improved Corrosion and Wear Resistance
... PEO coatings and materials used as the commercial engine cylinder bores has not been reported ...PEO coatings were prepared in this work. The thin coatings with tailored surface morphology and ...
114
Influence of Drying Temperature on Protective Properties of Waterborne and Solventborne Epoxy Coatings
... waterborne coatings has been intensified over the last few years ...solventborne coatings, waterborne coatings contain only a smaller quantity of co-solvents (<5%) necessary for final film ...
11
Corrosion behavior of multilayer coatings deposited by PVD on Inconel 718 in Chloride and Sulphuric Acid solutions
... PVD coatings presented in this investigation a lower corrosion rate for AlCrN/TiCrSiN (R2) and AlCrN/AlCrN +CrN (R3) coatings in which have a corrosion rate of ...
14
Epoxidation Modification of Renewable Lignin to Improve the Corrosion Performance of Epoxy Coating
... The epoxy resin E44 contained ELG powders at various weight ratios (referred as 1 wt%, 2 wt%, 5 wt% and 10 wt%) were mixed with curing agent polyamide and solvent. The weight ratio of E44 and curing agent was 4:1. The ...
10
Microstructural Characterization of Shrouded Plasma-Sprayed Titanium Coatings
... The phase composition result of the X-ray diffraction analysis of the titanium feedstock powders is presented in Figure 4. From the XRD pattern, it was found that the HDH titanium powder was merely composed of a α-Ti ...
10
Tribological Behaviour of Plasma Sprayed Al2O3-TiO2 Coating on Al-6082T6 Substrate
... Ceramic coatings produced by Thermal Spray Techniques are widely used for a range of industrial applications to confer wear and erosion resistance, thermal insulation and corrosion ...surface. Coatings are ...
8
Radio-frequency plasma polymerized biodegradable carrier for in vivo release of cis-platinum
... copolymer coatings for barrier layer at 20W CW (Continuous Wave) plasma which was then followed by deposition of a copolymer in a 1W PW (Pulse ...the coatings were deposited for different time duration (t d ...
12
A Review For Microtechnology On Electrodeposited Metal Matrix Composite Coatings
... composite coatings are of interest primarily for wear or high thermal applications and are better than flame deposited ...using coatings is dominated by economic or technological considerations, that is, it ...
5
Comparative Analysis of the Friction and Microstructural Properties of WC-10Co-4Cr and Cr3C2-25NiCr Coatings Sprayed by High-Velocity Oxy-fuel (HVOF)
... The standard governing the pin-on-disc test is designated by ASTM as G99-04 [18]. This regulation provides a standard, laboratory-level method for conducting material wear tests during sliding using the pin-on-disc ...
7
Preparation and Properties of Ni-W-rGO Composite Coatings
... surface functional groups, graphene is poorly dispersible in aqueous solutions ...surface functional groups [10], such as hydroxyl, epoxy, carbonyl, or ...
13
Fabrication of Ni-CeO2 Nanocomposite Coatings Synthesised via a Modified Sediment Co-Deposition Process
... nanocomposite coatings lead to improvement of the mechanical, tribological, anti-corrosion, and anti-oxidation properties of the coatings ...electrodeposited coatings [27, ...nanocomposite ...
14
Performance of Polypyrrole Coatings Against the Corrosion of Low Carbon Steel in Various Corrosive Environments
... PPY coatings, we have synthesized the coatings by 5, 10, 15 and 20 cycles from -500 mV to 1500 mV at a scan rate of 20 mV/sec and the potentiodynamic polarization resistance measurements were performed in ...
6
Antimicrobial Activity of Biodegradable Polysaccharide and Protein-Based Films Containing Active Agents
... García MA, Pinotti A, Martino MN & Zaritzky NE. 2009. Characterization of Starch and Composite Edible Films and Coatings. In: Huber, K. C. & Embuscado, M. E., editors. Edible Films and Coatings for ...
44