• No results found

in-band carrier signal

“DESIGN AND SIMULATION OF DOUBLE SIDE BAND SUPPRESSED CARRIER MODEL USING MATLAB SIMULINK TOOL AND EFFECT OF NOISE ON SIMULATION RESULTS USING MATLAB CODING”

“DESIGN AND SIMULATION OF DOUBLE SIDE BAND SUPPRESSED CARRIER MODEL USING MATLAB SIMULINK TOOL AND EFFECT OF NOISE ON SIMULATION RESULTS USING MATLAB CODING”

... modulated signal by the carrier signal, the result is a scaled version of the original message signal plus a second ...this signal passes through a low pass filter, the higher frequency ...

13

Non Contiguous Tri band Receiver for Carrier Aggregation RF System

Non Contiguous Tri band Receiver for Carrier Aggregation RF System

... RF signal where the information is distributed on non-contiguous frequency ...conversion band of the Analog to Digital Converter (ADC) to 100 ...RF signal in the band 2-3 GHz with a bit rate ...

13

A time frequency localized signal basis for multi carrier communication

A time frequency localized signal basis for multi carrier communication

... sharp signal transitions as shown in figure ...conjugate signal templates (matched filters) are optimal in Additive White Gaussian Noise (AWGN) ...smaller band-pass filters, whereby the ensemble is ...

65

Int. J. of Engg. Sci. & Mgmt. (IJESM), Vol. 2, Issue 2: April-June: 2012, 261-265

Int. J. of Engg. Sci. & Mgmt. (IJESM), Vol. 2, Issue 2: April-June: 2012, 261-265

... high band width data transmission, by converting the wideband signal into a parallel narrow band signals for parallel ...narrow band signals are executed with orthogonal frequency ...OFDM ...

5

Tuneable Dual-band Antenna for Sub 1 GHz Cellular Mobile Radio Applications

Tuneable Dual-band Antenna for Sub 1 GHz Cellular Mobile Radio Applications

... dual band antenna, a concurrent dual band test bed system can be realised as shown in ...baseband signal processing takes place in the controller, where two different baseband I/Q signals are ...

6

Analysis of the spectrum transform for narrow band signal passing through nonlinear section of a digital radar receiver

Analysis of the spectrum transform for narrow band signal passing through nonlinear section of a digital radar receiver

... strong signal, some people have the idea of trying to take advantage of the nonlinearity to realize automatic gain control ...the signal frequency bands are duplicated and shifted to the position of each ...

10

A Novel Ultra Wide Band Signal Generation Scheme Based on Carrier Interference and Dynamics Suppression

A Novel Ultra Wide Band Signal Generation Scheme Based on Carrier Interference and Dynamics Suppression

... UWB signal communication system, if no low frequency sinusoid FM signal at the transmitter end, the received signal strength will get attenuation with the square of ...synthesis signal at the ...

6

Development and characterization of an acousto-optic modulator

Development and characterization of an acousto-optic modulator

... electronic signal in order to produce sound ...RF carrier frequency oscillator, a balanced diode RF mixer for impressing an electronic video signal onto the carrier and a wide band ...

35

This chapter covers installation, configuration, and troubleshooting for both the T-1 and the E-1 digital trunk interfaces. The chapter includes the following sections:

This chapter covers installation, configuration, and troubleshooting for both the T-1 and the E-1 digital trunk interfaces. The chapter includes the following sections:

... The signal type option on an E-1 carrier refers to the in-band signaling on an E- 1 carrier and is analogous to the circuit signaling option on a ...

32

A Modification of Concurrent Dual Band Radio Receiver Architecture

A Modification of Concurrent Dual Band Radio Receiver Architecture

... ABSTRACT: Channels linking information sources and receivers are one of the fundamental blocks of all communication system. The size of the dust particle present in space, those of snows and rain drops are known to ...

9

Digital power line communication on EHV power lines

Digital power line communication on EHV power lines

... The function of the line trap is to present a high impedance at the carrier frequency and negligibly small impedance at power frequency, thereby preventing the carrier signal from bein[r] ...

194

Simulated signal and noise profiles in distribution line carrier networks

Simulated signal and noise profiles in distribution line carrier networks

... In Figure 4.2.4. the measured values of network response with the series impedance of 470 ohms are plotted along with the response pre- dieted at each of the test points using the comput[r] ...

74

The effect of distribution transformers on carrier signal propagation for a power distribution line at power line carrier frequencies

The effect of distribution transformers on carrier signal propagation for a power distribution line at power line carrier frequencies

... The distributed parameter network of figure 201 will now be directly applied to a distribution line and provisions will be made to incorporate the effect of the distribution transformers[r] ...

86

Impact of Doping in Gate All Around Nanowire TFET

Impact of Doping in Gate All Around Nanowire TFET

... TFET structure is similar to MOSFET, but with opposite type doping in Source and Drain. The simplest TFET is a gated P-i-N diode where the source and drain are highly doped with the gate controlling the ...

8

Crossover from lattice to plasmonic polarons of a spin polarised electron gas in ferromagnetic EuO

Crossover from lattice to plasmonic polarons of a spin polarised electron gas in ferromagnetic EuO

... With increasing carrier density, the plasma frequency becomes larger than the phonon frequency (Fig. 4b). The electron−phonon interaction therefore becomes efficiently screened 23 , and so the electron−phonon ...

8

Clipping Based PAPR Reduction Method for LTE OFDMA Systems

Clipping Based PAPR Reduction Method for LTE OFDMA Systems

... At the transmitter side, a baseband modulator transmits the binary input to multilevel sequences of complex number in one of several possible modulation formats including, quandary phase shift keying (QPSK), and 16 ...

5

Vol 7, No 6 (2017)

Vol 7, No 6 (2017)

... If the output is to be truly sinusoidal PWM, it is important to include very small pulses when the peak modulation signal is close to the peak carrier voltage. These small pulses can contribute ...

6

Energy Detection Based Periodic Dynamic Spectrum Sensing Using Cognitive Radio

Energy Detection Based Periodic Dynamic Spectrum Sensing Using Cognitive Radio

... different carrier signal spread over the spectrum and combined together to cover the whole ...combined signal and individual primary user signal is ...user signal is compared with the ...

6

1.
													Multi-rate signal processing sub-band coding for speech signal

1. Multi-rate signal processing sub-band coding for speech signal

... sub band-coding system the input signal, after being sampled at its Nyquist rate, is divided into channels by first being passed through a bank of low pass and high pass ...input signal[1]. It is ...

7

B5_Radio_Digital_Modulation.pdf (1574k)

B5_Radio_Digital_Modulation.pdf (1574k)

... An unsynchronous FSK system is modulated by a digital signal and operates at 10 MHz. The frequency deviation is 850 Hz and bit rate is 110 bit/s. The peak to peak carrier signal is 2 V and noise ...

34

Show all 10000 documents...

Related subjects