• No results found

liquid-liquid equilibrium

Liquid-Liquid Equilibrium for System Composed of α-Pinene, α-Terpineol and Water - Volume 4 Number 1 (Feb. 2013) - IJCEA

Liquid-Liquid Equilibrium for System Composed of α-Pinene, α-Terpineol and Water - Volume 4 Number 1 (Feb. 2013) - IJCEA

... phase equilibrium are required. The aim of this paper is to present liquid-liquid equilibrium (LLE) of system containing α-pinene, α-terpineol and ...thermodynamic equilibrium models ...

5

Liquid-liquid equilibrium data prediction using large margin nearest neighbor

Liquid-liquid equilibrium data prediction using large margin nearest neighbor

... the liquid-liquid equilibrium (LLE) phase diagram behavior is still inadequate and no comprehensive theory exists for the prediction of the experimental ...LLE equilibrium of guanidine ...

19

Liquid-Liquid Equilibrium Behavior and In Vitro Digestion Simulation of Medium Chain Fatty Acids

Liquid-Liquid Equilibrium Behavior and In Vitro Digestion Simulation of Medium Chain Fatty Acids

... Different mass salt concentrations were tested in this study, as given in Table 3. These concentrations were defined from the suggested concentrations given in the literature for each salt (Minekus et al., 2014). All ...

18

Liquid-Liquid Equilibrium for the Ternary Systems of Solvent+ m/o/p-Cresol+Water: Thermodynamic Modeling

Liquid-Liquid Equilibrium for the Ternary Systems of Solvent+ m/o/p-Cresol+Water: Thermodynamic Modeling

... uses liquid-liquid extraction, membrane adsorption, ion exchange, and mixed processes, including liquid-liquid ex- traction and adsorption [7, ...

9

On The Rupture of a Liquid Film Formed on a Droplet Crossing a Horizontal Liquid Liquid Interface

On The Rupture of a Liquid Film Formed on a Droplet Crossing a Horizontal Liquid Liquid Interface

... the liquid in case of ...of liquid mole- cules with the walls plays an important role; if the inter- action is weak, the liquid is expected to rupture on the wall surface and not in the ...free ...

6

Investigation of immiscible liquid liquid displacement in Slippery Liquid Infused Membranes (SLIM)

Investigation of immiscible liquid liquid displacement in Slippery Liquid Infused Membranes (SLIM)

... these measurements while the pressures are much higher than for the other surfactant solutions. As mentioned before (and shown in Section 4.2), DDAPS was tested on membrane II, which exhibits much smaller pore sizes. ...

40

The splashing morphology of liquid-liquid impacts

The splashing morphology of liquid-liquid impacts

... The easiest method to estimate the quantity of air entrapped is to simply measure the diameter of all the bubbles formed. While this is sufficient for bubbles > 30 µm, the smaller bubbles that are near and below the ...

36

The splashing morphology of liquid-liquid impacts

The splashing morphology of liquid-liquid impacts

... Single drop impact onto liquid films: Neck distortion, jetting, tiny bubble entrainment, and crown formation.. Impact with a liquid surface, studied by the aid of instantaneous photograp[r] ...

26

The splashing morphology of liquid-liquid impacts

The splashing morphology of liquid-liquid impacts

... impinging on each other. This action would cause a stagnation point to form which would in turn form a zone of high pressure. This high pressure zone will drive two high- pressure jets in opposite orthogonal directions ...

43

The splashing morphology of liquid-liquid impacts

The splashing morphology of liquid-liquid impacts

... This six stage model includes • Expansion and wave swell growth • Peak wave swell height • Wave swell drainage • Cavity base stagnation • Vortex formation • Flow convergence along centre[r] ...

26

The splashing morphology of liquid-liquid impacts

The splashing morphology of liquid-liquid impacts

... This chapter has presented the most complete and comprehensive picture of the splashing phenomena resulting from liquid-liquid impacts to date. New flow behaviour has been identified including microbubble ...

27

The splashing morphology of liquid-liquid impacts

The splashing morphology of liquid-liquid impacts

... The initial development of the upward jet is shown in Figure 3.28 (A8). Here the jet is not totally perpendicular to the free surface. Rather it is curved towards the side of the cavity resulting in most of the initial ...

30

The splashing morphology of liquid-liquid impacts

The splashing morphology of liquid-liquid impacts

... Another interesting feature observed in this regime is the formation of small bubbles almost immediately after impact has been made (Figure 3.4). These bubbles are similar to the bubbles reported by Thoroddsen et al. ...

14

Liquid Pre Freezing Percolation Transition to Equilibrium Crystal in Liquid Mesophase

Liquid Pre Freezing Percolation Transition to Equilibrium Crystal in Liquid Mesophase

... and liquid states, along supercritical isotherms to be equal ...the liquid with one large cluster. There can be no such crystal-liquid relationship as the ri- gidity of a crystal is expected behave ...

16

Air-assisted Liquid-liquid Microextraction vs. Dispersive Liquid-liquid Microextraction; A Comparative Study for the Analysis of Multiclass Pesticides

Air-assisted Liquid-liquid Microextraction vs. Dispersive Liquid-liquid Microextraction; A Comparative Study for the Analysis of Multiclass Pesticides

... as liquid-liquid extraction (LLE) [7,8], solid phase extraction (SPE) [9,10], QuEChERS [11], single drop microextraction (SDME) [12,13], and solid phase microextraction (SPME) [14,15] were previously ...

18

Simulation of Multistage Countercurrent Liquid-Liquid Extraction

Simulation of Multistage Countercurrent Liquid-Liquid Extraction

... words Liquid-Liquid extraction refers to a separation of constituents of liquid mixture by contacting it with suitable insoluble liquid solvent, which preferentially dissolves one or more ...

16

Crystal templating through liquid–liquid phase separation

Crystal templating through liquid–liquid phase separation

... Fig. 5. Dark field images of fluff-like water crystals in trans-DCE. The samples shown here are contained in a 2 mm deep by 10 mm wide quartz cuvette inside a cryostat cooled to 218 K. Scale bars are 1 mm. (a) In a ...

6

Stagewise Modeling of Liquid-Liquid Extraction Column (RDC)

Stagewise Modeling of Liquid-Liquid Extraction Column (RDC)

... Abstract Stagewise forward mixing model considering coalescence and redispersion of drops was used to predict the performance of Rotating Disc Liquid-Liquid Extraction Contactors. Experimental data ...

11

Dispersive Liquid-Liquid Microextraction and determination of Platinum(IV) by High Performance Liquid Chromatography

Dispersive Liquid-Liquid Microextraction and determination of Platinum(IV) by High Performance Liquid Chromatography

... dispersive liquid-liquid microextraction (DLLME), has been developed for the extraction and preconcentration of platinum (IV) in environmental water ...

7

New approaches for the study of the kinetics of reactions at immiscible liquid/liquid and air/liquid interfaces

New approaches for the study of the kinetics of reactions at immiscible liquid/liquid and air/liquid interfaces

... For the study of reactions at immiscible liquidlliquid interfaces, achieving a well-defined contact, with known interfacial area, under conditions where variable and high rates of mass t[r] ...

313

Show all 6941 documents...

Related subjects