• No results found

Nickel electroplating

Evaluation of conventional standards of nickel electroplating process for surface finish layer of AISI 316L stainless steel using copper rod bars as cathode

Evaluation of conventional standards of nickel electroplating process for surface finish layer of AISI 316L stainless steel using copper rod bars as cathode

... by electroplating process ...electroplated nickel annually distributed to the worldwide ...give nickel-electroplating features to be a modification of composition properties of the ...of ...

8

Effect of Metal Bipolar Plate Channel Fabrication on Electroplating – Using Nickel Electroplating of AISI 1045 Channel Substrate as an Example

Effect of Metal Bipolar Plate Channel Fabrication on Electroplating – Using Nickel Electroplating of AISI 1045 Channel Substrate as an Example

... The effect of milling process parameters on surface roughness of AISI 1045 steel BPPs was investigated. Our results showed that feed rate is highly responsible for the surface roughness. The BPP channel fabricated ...

14

Influence of Commercial Organic Additives on the Nickel Electroplating

Influence of Commercial Organic Additives on the Nickel Electroplating

... It is also noteworthy that most compounds identified in bibliographic studies are practically in disuse, as saccharin and coumarin. These additives are less efficient when compared to more advanced products and are still ...

15

Ultrasonic treatment with nickel electroplating combined with oxidation for developing y Al2O3 washcoat on Fe Cr Al substrate

Ultrasonic treatment with nickel electroplating combined with oxidation for developing y Al2O3 washcoat on Fe Cr Al substrate

... Catalyst material was prepared by using nickel electroplating. The oxidation kinetics was conducted at temperatures of 500, 700, 900 and 1100 o C in air for 100 hours. The surface morphology, cross section ...

51

High speed electroplating of nickel over stainless steel

High speed electroplating of nickel over stainless steel

... the nickel plating and stainless steel part has been ...for electroplating is difficult, for example wood’s nickel strikes are very sensitive to metallic impurities or the strike deposit is usually ...

16

Influence of Nickel Electrodeposition on Tensile Strength of Carbon Fibre Tow Material

Influence of Nickel Electrodeposition on Tensile Strength of Carbon Fibre Tow Material

... during nickel electroplating process, which results in a dramatic reduction of the tensile strength parameter for nickel-coated carbon fibre composites, as compared to that observed for a substrate, ...

5

Preparation of nio catalyst on fecral substrate using various techniques at higher oxidation process

Preparation of nio catalyst on fecral substrate using various techniques at higher oxidation process

... analysis in nanometer range scale. Meanwhile, roughness test was used for roughness measurement analysis in micrometer range scale. The scanning electron microscope (SEM) attached with energy dispersive X-ray (EDX) were ...

49

Application of design of experiment technique in the nickel-chromium electroplating process on WC-Co substrate prior HFCVD diamond coating

Application of design of experiment technique in the nickel-chromium electroplating process on WC-Co substrate prior HFCVD diamond coating

... for nickel electroplating 70 ...for nickel electroplating 70 ...chromium electroplating 70 4.1 Data for part one of nickel electroplating, the first-order model 78 ...of ...

24

Electrocoagulation Treatment of Electroplating Industrial Effluent

Electrocoagulation Treatment of Electroplating Industrial Effluent

... Electroplating industrial effluent consist of many sorts of heavy metals which are toxic in nature and may also contain varying range of pH, electrical conductivity, colour etc. Such waste water should mandatorily ...

5

Nickel and nickel oxide nanocrystals selectively grafting on multiwalled carbon nanotubes

Nickel and nickel oxide nanocrystals selectively grafting on multiwalled carbon nanotubes

... and nickel oxide nanocrystals in their pure phase are carefully embellished by a facial method on oxygen-functionalized multi-walled carbon nanotubes (O-MWCNTs) using nickel nitrate (NN) was effectively ...

5

Electroplating of Palladium for Electrical Contacts158-166

Electroplating of Palladium for Electrical Contacts158-166

... Furthermore, if during storage hydrogen diffuses from deposits with higher hydrogen : palladium ratios, the decomposition of the jl-phase and the accompanying change in [r] ...

9

Influence of Calcium Chloride Addition on Coal Based Reduction Roasting of Low Nickel Garnierite Ore

Influence of Calcium Chloride Addition on Coal Based Reduction Roasting of Low Nickel Garnierite Ore

... 10(a). Nickel and iron are not reduced effectively and cannot be enriched by magnetic separation, which results in poor recovery of nickel, as shown in Table ...

8

revision notes.pdf

revision notes.pdf

... Electrolysis occurs when an electric current splits water into hydrogen and oxygen. Electroplating[r] ...

38

Hydrodeoxygenation of Anisole in a Novel Externally Agitated Reactor

Hydrodeoxygenation of Anisole in a Novel Externally Agitated Reactor

... experiments. Nickel-based catalysts were selected since they have been shown effective for HDO, have a relatively low cost and are available, while also extensively studied for HDO in batch reactors, providing ...

105

The design and control of anaerobic ponds with specific reference to Western Treatment Plant

The design and control of anaerobic ponds with specific reference to Western Treatment Plant

... no discernible effect of nickel on acetoclastic methanogenic activity.. Figure 5-6 Effect of nickel ion on methanogenic activity. Table 5-7 Concentrations of nickel in test vials.. conce[r] ...

369

A New Single Flow Zinc-Nickel Hybrid Battery Using a Ni(OH)2-O2 Composite cathode

A New Single Flow Zinc-Nickel Hybrid Battery Using a Ni(OH)2-O2 Composite cathode

... copper foil electrodeposited with metallic zinc, and the cathode was the nickel hydroxide and oxygen composite electrode. High efficiencies were achieved with an average coulombic efficiency of 99.2% and an energy ...

9

Characterization and comparison between porous anodized aluminum colored by nickel and tin deposition

Characterization and comparison between porous anodized aluminum colored by nickel and tin deposition

... of nickel oxide, where low density of nickel content was measured and higher potential required for nickel oxidation The high absorbance of colored samples perceived as a promised surfaces for ...

10

Electroplating in Steel in Presence of Isopropanol-Water Mixture

Electroplating in Steel in Presence of Isopropanol-Water Mixture

... On addition of alcohol to water, the acidity decreases strongly due to breakdown of the open tetrahedral structure of water [30]. This concept explains the decrease in the rate of electroplating with the addition ...

13

Investigation of surface modification of perovskite with different catalysts

Investigation of surface modification of perovskite with different catalysts

... LSGT10 with reduction pre-treatment was coated with palladium catalyst in air. However, palladium did not dissolve into the perovskite even with an extended firing time. The sample was then coated with palladium in ...

189

Proposal for a Council Decision on acceptance of the terms of reference at the International Study Group on Nickel. COM (91) 337 final, 19 September 1991

Proposal for a Council Decision on acceptance of the terms of reference at the International Study Group on Nickel. COM (91) 337 final, 19 September 1991

... a "The Group" means the International Nickel Study Group as constituted in these Terms of Reference; b "Nickel" shall include, inter alia, scraps, wastes, and/or residues and such nickel[r] ...

15

Show all 2497 documents...

Related subjects