• No results found

out-of-plane geometries

Out of plane transport in ZrSiS and ZrSiSe microstructures

Out of plane transport in ZrSiS and ZrSiSe microstructures

... previously been stated, 20 and other transport measurements have shown, 16,17,22,23 that there is a very small quantum oscillation ampli- tude of the in-plane resistivity for in-plane applied fields, which ...

8

Collapse of 3D orthogonal woven carbon fibre composites under in-plane tension/compression and out-of-plane bending

Collapse of 3D orthogonal woven carbon fibre composites under in-plane tension/compression and out-of-plane bending

... 12 within the central weft tow stack, as highlighted in Figure 5(a). Again, both top and bottom surface tows have significant stress concentrations owing to crimping induced by the TTT- reinforcement. However, as the ...

38

Determining Optimal Geometries of Plane Stress Truss Structures using Numerically Mapped Principal Stress Trajectories.

Determining Optimal Geometries of Plane Stress Truss Structures using Numerically Mapped Principal Stress Trajectories.

... Simulated annealing is an optimization algorithm that mimics the crystallization process in heating and annealing of metals. This comes from the idea that, in annealing, the metal particles will move essentially at ...

176

The in-plane linear elastic constants and out-of-plane bending of 3-coordinated ligament and cylinder-ligament honeycombs

The in-plane linear elastic constants and out-of-plane bending of 3-coordinated ligament and cylinder-ligament honeycombs

... honeycomb geometries to the commonly used conventional hexagon is expanded, and the ability to tailor the mechanical response due to the new geometries has been demonstrated (including auxetic ...

23

Cyclic out-of-plane shear behaviour of sc composite structures

Cyclic out-of-plane shear behaviour of sc composite structures

... The specimens were tested using a unique three-point bending test setup that applied cyclic loading at the mid-span and had two support locations facilitated by round rods that pass through at the mid-height of the ...

10

Out of Plane Strength of Hollow Core Concrete Masonry Unit

Out of Plane Strength of Hollow Core Concrete Masonry Unit

... ABSTRACT: Precast construction techniques have gained huge popularity in the recent times due to rapid construction, excellent quality control and lesser labor costs and more overall savings. The most advanced typed of ...

12

In-plane effect on out-of-plane capacity of separated infill wall

In-plane effect on out-of-plane capacity of separated infill wall

... in- plane and out-of-plane interaction of the wall, first, various in-plane displacements were applied at the top of the ...the out-of-plane strength reduction due to ...

10

Numerical Modelling of Unreinforced Masonry Infill Walls under Seismic Load Considering In-Plane / Out-Of-Plane Interaction

Numerical Modelling of Unreinforced Masonry Infill Walls under Seismic Load Considering In-Plane / Out-Of-Plane Interaction

... which, out of 94 frames with at least one collapsed wall, 33 have both the panels at the first storey that did not reach ...4 out of 59 frames with collapsed ...IP plane forces are proportional to ...

162

Collapse load of pipe bends with assumed and actual cross sections under 
		in plane and out of plane moments

Collapse load of pipe bends with assumed and actual cross sections under in plane and out of plane moments

... The finite element limit analysis is popular to determine the collapse load (the moment at which the pipe bend fails) of the pipe bends. The loading cases causing the bend structure to collapse are in-plane ...

6

An Analysis of Local Out-of-Plane Buckling of Ductile Reinforced Structural Walls Due to In-Plane Loading.

An Analysis of Local Out-of-Plane Buckling of Ductile Reinforced Structural Walls Due to In-Plane Loading.

... resulting out-of-plane deformation and concrete damage can be seen in Figure 99 and Figure ...any out-of- plane instability, as shown in Figure ...

263

In-plane/out-of-plane disorder influence on the magnetic anisotropy of Fe1-yMnyPt-L10 bulk alloy

In-plane/out-of-plane disorder influence on the magnetic anisotropy of Fe1-yMnyPt-L10 bulk alloy

... supercells, depending on the desired level of doping, by two or four Mn. Mn was randomly positioned locally within each of the Fe planes, and we only applied the constraint that half of the Mn atoms were on each Fe ...

6

Experimental Approach to Determine the Stress at a Section of Semi Circular Curved Beam Subjected to Out Of Plane Load Using Strain Rosette

Experimental Approach to Determine the Stress at a Section of Semi Circular Curved Beam Subjected to Out Of Plane Load Using Strain Rosette

... to out-of-plane ...to out-of-plane loads have revealed some interesting ...to out-of-plane loads, it is shown that every section is subjected to a combination of transverse shear ...

6

SIMPLIFIED MODELING OF EFFECTS OF CONCRETE CRACKING ON OUT-OF-PLANE VIBRATIONS OF FLOORS

SIMPLIFIED MODELING OF EFFECTS OF CONCRETE CRACKING ON OUT-OF-PLANE VIBRATIONS OF FLOORS

... The dynamic properties of the SDOF oscillators are obtained from results of modal analyses of floor models extracted from the model with reduced out-of plane stiffness of slabs. Each one of the R/B major ...

10

Crystallographic and spectroscopic character­ization of 4 nitro 2 (tri­fluoro­meth­yl)benzoic acid and 4 nitro 3 (tri­fluoro­meth­yl)benzoic acid

Crystallographic and spectroscopic character­ization of 4 nitro 2 (tri­fluoro­meth­yl)benzoic acid and 4 nitro 3 (tri­fluoro­meth­yl)benzoic acid

... The Cambridge Structural Database (Groom et al., 2016) contains no isomers of nitro trifluoromethyl benzoic acid. A related derivative of 4-nitro-3-(trifluoromethyl)benzoic acid (II) is 3-methyl-4-nitrobenzoic acid ...

11

Analytical approach of buckling strength of yielding damped braced core (YDBC)

Analytical approach of buckling strength of yielding damped braced core (YDBC)

... Where z is longitudinal axis and x, y are principle axes, A is constant that is determined from the boundary conditions and a, is the total length of bracing member. A free body diagram of compression member is ...

6

Panel in–plane stiffness from vertical strain analysis in box compression test

Panel in–plane stiffness from vertical strain analysis in box compression test

... Out-of-plane Displacement • With bowing at central region, strain from bending and compression are coupled • Near vertical panel edges, out-of-plane displacement close to zero • Ideal to[r] ...

25

Enabling Concepts and Technologies for Out-Of-Plane Morphing Wing Structure: A Review

Enabling Concepts and Technologies for Out-Of-Plane Morphing Wing Structure: A Review

... wing out of its original plane in general involves three main shape parameters; twist, span-wise bending, and chord-wise ...from out-of-plane transformation are significant and efforts to ...

8

In-plane/out-of-plane disorder influence on the magnetic anisotropy of Fe1-yMnyPt-L10 bulk alloy

In-plane/out-of-plane disorder influence on the magnetic anisotropy of Fe1-yMnyPt-L10 bulk alloy

... set of different in–plane lattice parmeters and one out– of–plane value for each configuration. These geometri- cal changes promote electronic rearrangement and sig- nificantly alter the magnetic ...

6

Out-of-Plane Shear Strength of SC Walls: Effects of Additional Forces

Out-of-Plane Shear Strength of SC Walls: Effects of Additional Forces

... an out-of-plane shear force of 250 kips, and midspan deflection of ...the out of-plane shear force increased to 550 ...of out-of-plane ...

10

Combined Strengthening Techniques to Improve the Out-of-Plane Performance of Masonry Walls

Combined Strengthening Techniques to Improve the Out-of-Plane Performance of Masonry Walls

... much more brittle than the steel straps.. Load/displacement diagram of Specimen W2. a) Length of the crack for a load of 15 kN (delamination load of the compressed CFRP strip);. 490[r] ...

29

Show all 10000 documents...

Related subjects