• No results found

Plots of (a) temperature as a function of heat flux and (b) two-phase heat transfer coefficient as

Experimental estimation heat flux and heat transfer coefficient by using inverse methods

Experimental estimation heat flux and heat transfer coefficient by using inverse methods

... vection heat transfer coecient of air by using inverse heat transfer ...the temperature of the end of the last layer of insulation, it has been seen that the dierence between its ...

10

Experimental Investigation of Convective Heat Transfer Coefficient of CNTs Nanofluid under Constant Heat Flux

Experimental Investigation of Convective Heat Transfer Coefficient of CNTs Nanofluid under Constant Heat Flux

... Additionally, two thermocouples were inserted into the flow at the inlet and outlet of the heat transfer ...constant temperature at the inlet of test section, the heated fluid passes through a ...

6

Single Phase And Two Phase Flow For Heat Transfer In Micro Channel Heat Sink

Single Phase And Two Phase Flow For Heat Transfer In Micro Channel Heat Sink

... increased heat dissipation from those ...in heat generation, the size of conventional microchannel heat sinks had to be ...high heat flux generating electronics was often limited by the ...

24

Fundamental issues, technology development and challenges of boiling heat transfer, critical heat flux and two phase flow phenomena with nanofluids

Fundamental issues, technology development and challenges of boiling heat transfer, critical heat flux and two phase flow phenomena with nanofluids

... boiling heat transfer and CHF in pool boiling with nanofluids Studies on the fundamentals, theory and mechanisms of nucleate boiling heat transfer and CHF phenomena in pool boiling with ...

140

Simulation of Two-Phase Flow and Heat Transfer in Shell-Tubes Heat Exchanger

Simulation of Two-Phase Flow and Heat Transfer in Shell-Tubes Heat Exchanger

... Abstract:-Heat transfer of two-phase flow in shell and tubes heat exchanger ...a two-phase flow. Heat transfer to flow of mixture (air–water) through tubes ...

15

Iterative calculation of the heat transfer coefficient

Iterative calculation of the heat transfer coefficient

... the heat sink is in free air we must add this other convection which has a different h ...the heat sink in example 1 with heat generated by a 4 x 4 mm LED die set in the middle of the plane as show ...

9

Two phase flow and heat transfer in reflux thermosyphons

Two phase flow and heat transfer in reflux thermosyphons

... different two-phase flow ...corresponding temperature trace plots for low pressure water and ethanol in Table ...steady temperature traces in Table ...

194

Convective heat transfer in a closed two-phase thermosyphon

Convective heat transfer in a closed two-phase thermosyphon

... called two-phase thermosyphon, and is used to cool turbine blades, has been studied quite intensively in the 60 years of the last ...high) heat transfer ability of ...of heat ...

7

Heat transfer to two-phase flow in inclined tubes

Heat transfer to two-phase flow in inclined tubes

... and heat transfer in air–water flow in 8° inclined tubes of inner diameter of ...local heat transfer coefficients were obtained byinfrared ...the heat transfer coefficients, together ...

22

On heat transfer to pulsatile flow of a two phase fluid

On heat transfer to pulsatile flow of a two phase fluid

... A TWO-PHASE FLUID ...of heat transfer to pulsatile flow of a two-phase fluid-particle system con- tained in a channel bounded by two infinitely long rigid impervious ...

14

IHTC14- NANO-STRUCTURED TWO-PHASE HEAT SPREADER FOR COOLING ULTRA-HIGH HEAT FLUX SOURCES

IHTC14- NANO-STRUCTURED TWO-PHASE HEAT SPREADER FOR COOLING ULTRA-HIGH HEAT FLUX SOURCES

... applied heat flux, and therefore, different amounts of charge were used for individual test ...the heat transfer coefficient for both evaporation and ...
Simultaneous Determination of Reference Free-Stream Temperature and Convective Heat Transfer Coefficient

Simultaneous Determination of Reference Free-Stream Temperature and Convective Heat Transfer Coefficient

... reference temperature when convective temperature because it should be used to calculate the temperature ...determine heat transfer coefficient and reference free stream ...

6

Adiabatic wall temperature and heat transfer coefficient influenced by separated supersonic flow

Adiabatic wall temperature and heat transfer coefficient influenced by separated supersonic flow

... tunnel: temperature – with the use of two insulated chromel-alumel thermocouples, static pressure – with the use of probes Honeywell ...Wall temperature of the experimental model was recorded by 6 ...

5

Analysing the Effectiveness of the Heat Exchanger by Increasing Overall Heat Transfer Coefficient

Analysing the Effectiveness of the Heat Exchanger by Increasing Overall Heat Transfer Coefficient

... A heat exchanger is heat transfer device that is used to transfer the internal heat energy between two or more fluids available at different ...existing heat exchangers, ...

6

Experimental evaluation of heat transfer coefficient for nanofluids

Experimental evaluation of heat transfer coefficient for nanofluids

... of heat transfer experimental tests on ...a two-loop test rig for immediate comparison of the thermal performances of the nanofluid with the ...convective heat transfer was evaluated in ...

8

Mathematical Modeling of Hydrodynamic and Heat Transfer in a Two-Phase Thermosyphon

Mathematical Modeling of Hydrodynamic and Heat Transfer in a Two-Phase Thermosyphon

... convective heat exchange at the external top horizontal boundary on the heat transfer intensity in such energy removing device is ...that temperature distributions in thermosyphon steam ...

6

Numerical Analysis of Two Phase Flow and Heat Transfer in Condensers

Numerical Analysis of Two Phase Flow and Heat Transfer in Condensers

... The Pareto front provided by the MOTPSO algorithm contains a diverse and distributed set of optimal solutions because of the diversity-preserving capability of the algorithm and the nearest neighbor density estimator ...

129

Mathematical modeling of heat transfer in closed two-phase thermosyphon

Mathematical modeling of heat transfer in closed two-phase thermosyphon

... of heat-transfer in close two-phase thermosyphon of cylindrical form in the condition of admission of warmth on a lower lid and taking from the high bound of ...of heat conductivity in ...

6

An Investigation of Heat Transfer for Two-Phase Flow (Air-Water) in Shell and Tubes Heat Exchanger

An Investigation of Heat Transfer for Two-Phase Flow (Air-Water) in Shell and Tubes Heat Exchanger

... average heat transfer coefficient using thermocouples, through study found its dependence on air and water ...on two-phase heat transfer, almost of them about refrigerants ...

14

Convective  heat  transfer  in  a  dusty  ferromagnetic  fluid  over  a  stretching surface with prescribed surface temperature/heat flux  including heat source/sink

Convective heat transfer in a dusty ferromagnetic fluid over a stretching surface with prescribed surface temperature/heat flux including heat source/sink

... and heat generation/absorption parameter on the temperature and velocity profiles are considered graphically for two types of heating processes, namely, the prescribed surface temperature ...

11

Show all 10000 documents...

Related subjects