• No results found

Preparation of the thermally modified stationary phase

Preparation and Characterization of Hydrophilically Modified PVDF Membranes by a Novel Nonsolvent Thermally Induced Phase Separation Method

Preparation and Characterization of Hydrophilically Modified PVDF Membranes by a Novel Nonsolvent Thermally Induced Phase Separation Method

... As shown in Figure 12, the normalized fluxes J f /J i due to fouling and J r /J i after physical cleaning were used to evaluate the antifouling performance of the membranes. In the first filtration step as described in ...

16

Preparation of ion exchange columns with longitudinal stationary phase gradients

Preparation of ion exchange columns with longitudinal stationary phase gradients

... • Preparation of stationary phase gradients requires introduction of the gradient after the column was packed. • Latex coatings are routinely applied during the manufacture of many ion [r] ...
Preparation and Characterization of Titania Microspheres and Their Application in a Liquid Chromatography Stationary Phase

Preparation and Characterization of Titania Microspheres and Their Application in a Liquid Chromatography Stationary Phase

... Abstract Titania microspheres were synthesized using hydrothermal methods to exploit a new liquid chromatography stationary phase. The prepared titania microspheres were approximately 7 µm in diameter, and ...

8

Yeast Rpi1 Is a Putative Transcriptional Regulator That Contributes to Preparation for Stationary Phase

Yeast Rpi1 Is a Putative Transcriptional Regulator That Contributes to Preparation for Stationary Phase

... The RPI1 gene of Saccharomyces cerevisiae was identified initially as a dosage suppressor of the heat shock sensitivity associated with overexpression of RAS2 (J. Kim and S. Powers, Mol. Cell. Biol. 11:3894–3904, 1991). ...

10

Preparation and characterization of polyethylene/ glass fiber composite membrane prepared via thermally induced phase separation method

Preparation and characterization of polyethylene/ glass fiber composite membrane prepared via thermally induced phase separation method

... In this study, grinded glass fiber embedded HDPE membranes were prepared via thermally induced phase separation method. The results from this study showed that all of the membranes had leafy structure, ...

12

Preparation and Characterization of Electrically and Thermally Conductive Polymeric Nanocomposites

Preparation and Characterization of Electrically and Thermally Conductive Polymeric Nanocomposites

... In the present study, AlN—epoxy composites prepared using solvent casting technique has been investigated. AlN particles at micro and nano levels have been used as a reinforcing filler to evaluate its effect on thermal ...

13

Three-Dimensional Wedge Diffraction Correction Deduced by the Stationary Phase Method on the Modified Equivalent Current Approximation (Meca)

Three-Dimensional Wedge Diffraction Correction Deduced by the Stationary Phase Method on the Modified Equivalent Current Approximation (Meca)

... The correction matrix C transforms the diffracted GO component deduced from MECA through the stationary phase method, into a GTD component. Note that the SPM allows us to mathematically obtain matrix C; ...

21

Chemical and ultrastructural aspects of thermally modified wood with emphasis on durability

Chemical and ultrastructural aspects of thermally modified wood with emphasis on durability

... drying phase, the temperature inside the kiln is increased between 185 and 215℃ depending on the application of the treated products and is then maintained at that level for a 2 to 3 h ...

70

Life-Cycle Assessment Of Thermally-Modified Southern Pine Decking

Life-Cycle Assessment Of Thermally-Modified Southern Pine Decking

... second phase of an LCA where data collection and calculation procedures were utilized to quantify the relevant inputs and outputs of the two wood decking products during each life-cycle ...

291

Adsorption of Methyl Violet Dye by Thermally Modified Ceiba Pentandra Sawdust

Adsorption of Methyl Violet Dye by Thermally Modified Ceiba Pentandra Sawdust

... aqueous and solid phase. Hence, the higher initial concentration of methyl violet will enhance the adsorption process. Effect of pH toward Methyl Violet Adsorbed pH has been referred as an important influencing ...

7

Phase optimization of thermally actuated piezoresistive resonant MEMS cantilever sensors

Phase optimization of thermally actuated piezoresistive resonant MEMS cantilever sensors

... sensing components is necessary in such a way as to re- duce the thermal coupling effect. Stationary FEM simula- tion delineated in Fig. 5b, c, and d shows that shifting HR away from WB yields a lower thermal ...

12

Effects of thermally modified green tea catechins on the oxidative and hydrolytic stability of butter

Effects of thermally modified green tea catechins on the oxidative and hydrolytic stability of butter

... NMC preparation (-) form cate- chins (2S, 3R) constituted approximately 10% of the total ...the preparation the amount of (-) forms (2S, 3R) in HMC1 and HMC2 increased to 20 and 30% of total catechins, ...

5

Tribological Behavior of Thermally Sprayed Coatings with Different Chemical Composition and Modified by Remelting

Tribological Behavior of Thermally Sprayed Coatings with Different Chemical Composition and Modified by Remelting

... Binary phase diagrams such as NiCr, NiB, and NiSi provide information on the effects of individual alloying elements ...solution phase  -Ni and low content of Ni-Ni 3 B eutectic ...

8

Dps Is a Stationary Phase Specific Protein  of Escherichia coli Nucleoid

Dps Is a Stationary Phase Specific Protein of Escherichia coli Nucleoid

... Growth phase dependent changes in the shape and size of ...sample preparation for fluorescence microscopy were discussed in the Materials and Methods ...= Phase contrast, which represents the cell ...

11

Medium Improvement for Higher Growth and Longer Stationary Phase of Dunaliella

Medium Improvement for Higher Growth and Longer Stationary Phase of Dunaliella

... Dunaliella salina DCCBC15 was kindly provided by Dr. E.W. Polle, Department of Biology, Brooklyn College of CUNY Brooklyn, NY (USA). The alga was grown and maintained in the low cost modified natural seawater ...

5

Preparation and Characterization of Polyisocyanurate Modified Polyimide Foam

Preparation and Characterization of Polyisocyanurate Modified Polyimide Foam

... Abstract Poly (isocyanurate-imide)s (PIR-PI)s foams have been prepared from the reaction of polyimide (PI) and polyisocyanurate (PIR) prepolymers with different weight ratios of PIRs. The synthesis involve a two stage ...

6

Effects of Water Soaking–drying Cycles on Thermally Modified Spruce Wood–plastic Composites.

Effects of Water Soaking–drying Cycles on Thermally Modified Spruce Wood–plastic Composites.

... was thermally modi fied and the other half was used as the UW ...drying phase at 103°C for 48 h before modi fi- cation, the heating phase, with the temperature increasing from 105°C over a period of ...

11

Properties of thermally modified wood

Properties of thermally modified wood

... However, more testing is needed in this area. Concerning termites, the problem is currently more apparent in Southern hemisphere locations, but termites have already spread through France and cases have also been ...

5

Professional Consumer Perceptions of Thermally-Modified Wood

Professional Consumer Perceptions of Thermally-Modified Wood

... Asterisks denote significant differences (t-test). ............................................................................ 47 Table 10. Respondent familiarity with forest certification. ...

167

Durability of polyacrylate nanocoatings on thermally modified wood

Durability of polyacrylate nanocoatings on thermally modified wood

... Na taj se naĉin ţeljelo utvrditi kako dodatak nanoĉestica UV apsorbera u premaz utjeĉe na kemijske promjene i promjenu boje toplinski modificiranog drva ispod premaza, te [r] ...

200

Show all 10000 documents...

Related subjects