• No results found

RF pilot tone

Receiver implemented RF pilot tone phase noise mitigation in coherent optical nPSK and nQAM systems

Receiver implemented RF pilot tone phase noise mitigation in coherent optical nPSK and nQAM systems

... (RF) pilot tone - which is used in the receiver to mitigate the phase noise by complex multiplication of the received signal field - is an obvious candidate [24,25], but other DSP based methods might ...

9

Phase noise influence in coherent optical OFDM systems with RF pilot tone : digital IFFT multiplexing and FFT demodulation

Phase noise influence in coherent optical OFDM systems with RF pilot tone : digital IFFT multiplexing and FFT demodulation

... When deriving the signal representation a procedure as in section 2.1 is followed. We consider an ideal system and neglect the influence of the guard time insertion and assume that the subcarrier recovery is perfect in ...

8

Phase noise influence in optical OFDM systems employing RF pilot tone for phase noise cancellation

Phase noise influence in optical OFDM systems employing RF pilot tone for phase noise cancellation

... use RF pilot tone phase noise cancellation, co- herent detection and a dispersion compensating fiber at the entrance of the coherent receiver to balance (at least roughly) the fiber ...

5

Study of EEPN mitigation using modified RF pilot and Viterbi Viterbi based phase noise compensation

Study of EEPN mitigation using modified RF pilot and Viterbi Viterbi based phase noise compensation

... (RF) pilot tone in the orthogonal polarization relative to the QPSK modulated signal and the Viterbi-Viterbi algorithm is applied for reducing EEPN ...

13

Phase noise cancellation in coherent communication systems using a radio frequency pilot tone

Phase noise cancellation in coherent communication systems using a radio frequency pilot tone

... an RF pilot tone orthogonally polarized against the transmitted ...the RF pilot tone was transmitted in the orthogonal polarization ...the RF pilot tone are ...

9

Stimulus frequency otoacoustic emissions and cochlea function

Stimulus frequency otoacoustic emissions and cochlea function

... Some of Abbas and Sach's (197 6) results, shown in their figure 8, are taken with a stimulus tone of 60dB SPL, the same level as the stimulus tone used by Kemp, Brass and Souter (1991). These results show ...

243

SATURN IIE EPABX A30808X5130-8120-1-8328

SATURN IIE EPABX A30808X5130-8120-1-8328

... 1.00 Mnemonics Used in This Practice . . . . . . . . . . . . . . l-l PCB and Supply Removal . . . . . 2 - 2 2.01 Visual . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 3 3.00 System Ground Test. . . . . . . . . ...

55

DKT2004-CT Cordless Digital Telephone User Guide

DKT2004-CT Cordless Digital Telephone User Guide

... If you hear busy tone after dialing an outside line access code or a station number, press $XWR&DOOEDFN or.. Busy tone stops, followed by success tone, then busy tone resumes.[r] ...

77

DKT2104-CT Cordless Digital Telephone User Guide

DKT2104-CT Cordless Digital Telephone User Guide

... If your station is in Do Not Disturb (DND) mode, internal, external and transferred calls do not ring your station and Off-hook Call Announce calls are denied. You can continue to make calls while in the DND mode. When ...

75

DEFINITY Enterprise Communications Server Application Notes for Type Approval

DEFINITY Enterprise Communications Server Application Notes for Type Approval

... Off-Premises Tone Detect Timeout Interval (seconds): 10 AAR/ARS Dial Tone Required? y Music/Tone on Hold: tone Music (or Silence) on Transferred Trunk Calls? no DID/Tie/ISDN Intercept ...

484

V-119RTVA VOICE ANNOUNCE V-119RTHF HANDSFREE TALKBACK 19 ZONE INTERCOM/PAGE CONTROL UNITS

V-119RTVA VOICE ANNOUNCE V-119RTHF HANDSFREE TALKBACK 19 ZONE INTERCOM/PAGE CONTROL UNITS

... To re-ring the same station, press the "*" button. The station will be signaled as long as the "*" is pressed. Personal signaling: When initiating a call, press the "*" and then the station ...

9

RF-Pilot Based Frequency Offset Estimation and Phase Noise Compensation for CO-OFDM Systems

RF-Pilot Based Frequency Offset Estimation and Phase Noise Compensation for CO-OFDM Systems

... the RF-pilot cannot be filtered out directly, regardless of using whether a low pass filter (LPF) or a band pass filter (BPF) in coherent ...performance, RF-pilot is required with large power ...

8

A mechanism for simultaneous suppression of tone burst-evoked otoacoustic emissions.

A mechanism for simultaneous suppression of tone burst-evoked otoacoustic emissions.

... Otoacoustic emissions (OAEs) are evident as sound emanating from the healthy cochlea, which may be recorded using a sensitive microphone placed in the ear canal. A commonly studied OAE is elicited in response to a brief ...

31

V-136RTHF 36 ZONE TALKBACK INTERCOM/ PAGE CONTROL UNIT

V-136RTHF 36 ZONE TALKBACK INTERCOM/ PAGE CONTROL UNIT

... When station user lifts handset to make an ICM page, the switchhook contacts in the telephone close the tip and ring to form a loop which returns battery back to turn on transistor Q1. Transistor Q1 operates relay and ...

8

RF Controlled Alive Human Detection Robot

RF Controlled Alive Human Detection Robot

... Radio Frequency robots are controlled using radio frequency signals, of different frequencies depending on the required range. Hence the name. Robots are used for a spectrum of applications, including in automobile ...

7

DO NOT push the PTT when not actually desiring to transmit.

DO NOT push the PTT when not actually desiring to transmit.

... RF attenuator: The transceiver has an RF attenuator related to the [SQL] setting. The attenuator is automatically activated when [SQL] is rotated further than the 12 o’clock position. Approx. 10 dB ...

80

KSU Line Connectors KSU Set Connector KSU External Battery Connectors KSU Door Answer Unit Connector KSU Power Fail Transfer Connector KSU Music Input Set Connector

KSU Line Connectors KSU Set Connector KSU External Battery Connectors KSU Door Answer Unit Connector KSU Power Fail Transfer Connector KSU Music Input Set Connector

... Current outside party is placed on hold; continuous tone is heard. Outside dial tone is heard; if desired line is unavailable, broken tone is heard. Call is made to [r] ...

69

1030 Attendant’s Guide

1030 Attendant’s Guide

... The Tone Commander 1030 console provides an easy to use answering position for Centrex or PABX lines. Calls may be put on hold or transferred from the console. Autodialing, message waiting light control, and ...

30

Tone Commander 1030/1560 Installation Instructions

Tone Commander 1030/1560 Installation Instructions

... The Tone Commander 1030 and 1560 are answering consoles for use in receptionist or departmental attendant positions, with Centrex or PABX systems. Line keys are provided for LDN (listed directory number) ...

68

I NTUITY Messaging Solutions Release 4.3 Update

I NTUITY Messaging Solutions Release 4.3 Update

... By default, the MERLIN LEGEND uses U.S. parameter settings for different switch tones in all countries. Therefore, all dial tone, busy tone detection, and reorder tones are based on U.S. settings. These ...

58

Show all 10000 documents...

Related subjects