• No results found

silicon content

Effect of Silicon Content on Intergranular Embrittlement of Ferritic Spheroidal Graphite Cast Iron Suffered from Cyclic Heating

Effect of Silicon Content on Intergranular Embrittlement of Ferritic Spheroidal Graphite Cast Iron Suffered from Cyclic Heating

... These observations agree well with the microstructural evolutions discussed in the previous sections. Furthermore, the variation of n value during tensile deformation also reflects inhomogeneous local yielding. A ...

8

Effect of Silicon content on the Mechanical Properties of Aluminum Alloy

Effect of Silicon content on the Mechanical Properties of Aluminum Alloy

... the silicon particles in aluminium alloy as shown in table ...in silicon content as shown in table ...the silicon content ...of silicon) 148.99 MPa, when we decrease the ...

5

Microstructure and mechanical properties of magnetron sputtered  Ti-Si-N coatings with different silicon content

Microstructure and mechanical properties of magnetron sputtered Ti-Si-N coatings with different silicon content

... on silicon (100) substrates. The Si content in the films could be easily controlled through changing the number of the Si pieces on a single TiN ...The silicon content was shown to have an ...

10

Silicon content in beers from Korean market and estimation of its alimentary uptake

Silicon content in beers from Korean market and estimation of its alimentary uptake

... for silicon intake. The deficiency of silicon induces deformities in skull and peripheral bones, and re- sults in poorly formed joints, reduced contents of cartilage and collagen, and the disruption of the ...

8

EFFECT OF SILICON CONTENT ON MACHINABILITY OF Al-Si ALLOYS

EFFECT OF SILICON CONTENT ON MACHINABILITY OF Al-Si ALLOYS

... 99.8%) and eutectic Etial 140 alloy with 12.5% Si content (12.5%Si, 0.6%Fe, 0.4%Mn, 0.1%Cu, 0.1%Zn, 0.1%Mg, 0.1%Ni, 0.1%Ti, 0.1%Pb con- tent) were used. Melting processes were carried out with an induction furnace ...

7

Effect of Morphology and Si Content on SiO2 Particle Erosion of
Full Pearlitic Spheroidal Graphite Cast Iron

Effect of Morphology and Si Content on SiO2 Particle Erosion of Full Pearlitic Spheroidal Graphite Cast Iron

... 3.2 The effect of pearlite morphology on erosion rate In order to investigate the effect of λ value of pearlitic struc- ture on erosion wear resistance, a comparison was made be- tween the erosion rate data for the ...

7

An Investigation into Solidification and Mechanical Properties Behavior of Al-Si Casting Alloys

An Investigation into Solidification and Mechanical Properties Behavior of Al-Si Casting Alloys

... with silicon as the major alloying elements are the most important commercial casting alloys because of their superior casting ...and silicon content (3%- 15% S ...element content and the ...

6

Determination of silicon in Czech beer and its balance during the brewing process

Determination of silicon in Czech beer and its balance during the brewing process

... of silicon in beer samples from the Czech market and in brewing raw materials and ...The content of silicon in barley malt depended on the barley variety and growing ...establish silicon ...

6

Effect of Silicon on Microstructure and Mechanical Properties of Al-Si Piston Alloys

Effect of Silicon on Microstructure and Mechanical Properties of Al-Si Piston Alloys

... eutectic silicon can also be seen in the inter-dendritic ...Eutectic silicon can be seen in the inter-dendritic ...of silicon has increased the eutectic amount present in the inter-dendritic ...of ...

5

The Application and Limitations of PECVD for Silicon-based Photonics

The Application and Limitations of PECVD for Silicon-based Photonics

... exhibit strong room temperature photoluminescence, with the optimum emission depending on the composition and processing of the films. The strongest emission was achieved for films with a silicon content of ...

9

Effect of Silicon on Grain Refinement of Aluminum Produced by Electrolysis

Effect of Silicon on Grain Refinement of Aluminum Produced by Electrolysis

... in silicon content, and reach the peak point when silicon content is about ...high silicon content was also found in the unrefined alloys 7,8) and the refined alloys with low ...

6

Plant available silicon in differentiated fertilizing conditions

Plant available silicon in differentiated fertilizing conditions

... available silicon in soil because phosphates strongly displace silicates from the solid phase to the soil solu- tion (Phonde et ...of silicon in the soil ...the content of available silicon ...

5

Effect of Silicon Particles on the EDM Characteristics of Al Si Alloys

Effect of Silicon Particles on the EDM Characteristics of Al Si Alloys

... highest silicon content (29Si) presents the highest average ridge number following ...the silicon content increased, the ridge den- sity value on the EDMed surface markedly increased with the ...

7

NTERNATIONAL JOURNAL OFR ESEARCH SCIENCE &M ANAGEMENT

NTERNATIONAL JOURNAL OFR ESEARCH SCIENCE &M ANAGEMENT

... Al content in the outer layer higher than that inter-diffusion ...with silicon modified aluminide coating outer layer divided into two region, the Al content concentrate in the region I and decrease ...

12

Correlation of Grain-to-grain Electrical Properties with Impurities and Defects in Solar Grade Polycrystalline Silicon

Correlation of Grain-to-grain Electrical Properties with Impurities and Defects in Solar Grade Polycrystalline Silicon

... liquid silicon during crystal growth; (ii) a difference in materia l, for example silicon and aluminum layer deposited on the back side of the wafer surface (this method is followed by AP); (iii) a ...

79

Preparation of Porous Silicon Nitride Ceramics by Microwave Sintering and Its Performance Evaluation

Preparation of Porous Silicon Nitride Ceramics by Microwave Sintering and Its Performance Evaluation

... porous silicon nitride ceramics is relatively low, all in the order of ...porous silicon nitride a candidate material for wave- transmitting dielectric ...Porous silicon nitride ceramics with ...

16

Impacts of Post metallisation Processes on the Electrical and Photovoltaic Properties of Si Quantum Dot Solar Cells

Impacts of Post metallisation Processes on the Electrical and Photovoltaic Properties of Si Quantum Dot Solar Cells

... inexpensive silicon thin-film technology in combination with a high- efficiency multi-band gap ...in silicon. When silicon is made very thin (of the order of a few nanometers) in one or more ...

6

On the Growth and Microstructure of Carbon Nanotubes Grown by Thermal Chemical Vapor Deposition

On the Growth and Microstructure of Carbon Nanotubes Grown by Thermal Chemical Vapor Deposition

... of CNTs in nano electronics, energy storage devices, optics, medical, and many others fields, an intense research is being carried out to find substrate and CNT combinations that can directly act as active/passive ...

6

The fabrication and analysis of hard Si3N4 based, dispersed phase composites

The fabrication and analysis of hard Si3N4 based, dispersed phase composites

... material. Silicon carbide, a traditional abrasive, possesses similarly attractive properties to those of Si3N4 and so can effectively toughen silicon nitride ceramics without adversely affecting the ...

210

Epoxy/Nano-SiO2 Anticorrosion Coatings Synthesized by Different Molar Ratio of Tetraethyl orthosilicate (TEOS) and Tetramethyl orthosilicate (TMOS)

Epoxy/Nano-SiO2 Anticorrosion Coatings Synthesized by Different Molar Ratio of Tetraethyl orthosilicate (TEOS) and Tetramethyl orthosilicate (TMOS)

... molar ratio. Nano-silica particles, which were synthesized by different molar ratio of tetraethyl orthosilicate (TEOS) and tetramethyl orthosilicate (TMOS), manifested different characteristics in particle size and ...

10

Show all 10000 documents...

Related subjects