• No results found

surface-resistance measurement method

Measurement of the Surface-Temperature Field in a Fog Lamp Using Resistance-Based Temperature Detectors

Measurement of the Surface-Temperature Field in a Fog Lamp Using Resistance-Based Temperature Detectors

... Modern headlamps are made from low-cost plastic materials that are very convenient for the design of these products. However, plastic materials are not suitable for use at high temperatures. The result can be ...

8

Measurement of resistance at low temperatures

Measurement of resistance at low temperatures

... d.c. method for resistance measurement was used. In this method 4-probes are attached at four points in a line on the sample ...points. Resistance is calculated using equation ...

5

A Novel Resistance Network Node Potential Measurement Method and Application in Grounding Grids Corrosion Diagnosis

A Novel Resistance Network Node Potential Measurement Method and Application in Grounding Grids Corrosion Diagnosis

... branch resistance and node voltage based on the Tellegon theory [6, 10, ...diagnosis method was proposed by establishing a block model [12, ...the surface electromagnetic field and establishes ...

12

Construction of Sheet Resistance Measurement Setup for Tin Dioxide Film Using Four Probe Method

Construction of Sheet Resistance Measurement Setup for Tin Dioxide Film Using Four Probe Method

... The substrate are generally required cleaning before the film deposition because of the dust and impurities particles on the surface of the substrate. This can adversely affect the growth of the films and also ...

6

Recent methodology advances in fluorescence molecular tomography

Recent methodology advances in fluorescence molecular tomography

... for reconstructing during FMT reconstruction. Moreover, it is very difficult to use the feasible region effectively when the internal light source of the imaging region is in a deep position or there are multiple ...

11

Ultraviolet radiation albedo and reflectance in review: the influence to ultraviolet exposure in occupational settings

Ultraviolet radiation albedo and reflectance in review: the influence to ultraviolet exposure in occupational settings

... similar surface types for ...same method using a spectrophotometer (single pass monochromators with diffraction grating) with integrating sphere, although not the same model of ...Test Method (ASTM) ...

21

Analytical Methods for Earth Surface Potential Calculation for Grounding Grids

Analytical Methods for Earth Surface Potential Calculation for Grounding Grids

... earth surface potential doesn’t vary significantly since the vertical rods are connected to grid in the homogenous ...earth surface potential when changing the vertical rods locations at the same number of ...

7

Evaluation of Corrosion Stability of Water Soluble Epoxy Ester Primer through Electrochemical Studies

Evaluation of Corrosion Stability of Water Soluble Epoxy Ester Primer through Electrochemical Studies

... polarization method may not be very useful in highly resistive coatings, still it can be employed as a quantita- tive method to evaluate the coating ...

15

Indium tin oxide (ITO) deposition, patterning and Schottky contact fabrication

Indium tin oxide (ITO) deposition, patterning and Schottky contact fabrication

... as the working gas. It was found that after ten minutes RIE, all the photoresist was etched, no thickness loss of ITO film was observed. This is because the photoresist was burned by oxygen plasma. Then, argon was chosen ...

90

Baaske, Philipp
  

(2010):


	Biomolecules in microthermal fields.


Dissertation, LMU München: Fakultät für Physik

Baaske, Philipp (2010): Biomolecules in microthermal fields. Dissertation, LMU München: Fakultät für Physik

... as Surface Plasmon Resonance ...The method is also applicable to the screen for new aptamers since the binding of unlabelled aptamers to a labelled target can also be quantified with ...

133

A Method of Insulator’s NSDD Measurement and Its Device Based on Laser Transmission Principle

A Method of Insulator’s NSDD Measurement and Its Device Based on Laser Transmission Principle

... Insulator pollution flashover is one of the important problems which influence the safety and stability of power system. Insulators of overhead transmission line operated under natural condition in long term and the ...

7

Investigation Of Soil Resistivity Base On Design Of An Experiment Approach

Investigation Of Soil Resistivity Base On Design Of An Experiment Approach

... Generally, materials have characteristics behaviour of resisting the flow of electrical charge. The ability to resist current is one of the physical properties that posses by any materials in this whole world. This ...

24

Data fusion of surface data sets of X-ray computed tomography measurements using locally determined surface quality values

Data fusion of surface data sets of X-ray computed tomography measurements using locally determined surface quality values

... of surface points classified as good qual- ity ...rated surface points (method three, ...low measurement deviation. To rank the results, a supplementary measurement has been introduced ...

7

Numerical Modelling of Behaviour of Surface Finishing of Composite Materials

Numerical Modelling of Behaviour of Surface Finishing of Composite Materials

... damage resistance of the lacquer or the coating system was quantified by means of a gravel ...chip resistance of coatings, more than twenty different test methods were ...in resistance and easier ...

6

Humidity effect on pressure velocity sensor examined in sound
absorption measurement with ensemble averaging technique

Humidity effect on pressure velocity sensor examined in sound absorption measurement with ensemble averaging technique

... The authors have proposed an absorption measurement method Ea-method that utilizes ensemble averaging and pressure-velocity sensor pu- sensor for measuring surface normal impedance requi[r] ...

7

Measurement of grain surface roughness

Measurement of grain surface roughness

... bulk surface are difficult and labour ...measuring method shall consist in the computer registration of pictures of the studied surface and an automatic comparative analysis with a model ...

6

Optical Methods of Surface Measurement

Optical Methods of Surface Measurement

... • Can apply scanning electron microscopy to obtain images with sub-micrometer resolution (Note: BKA research).[r] ...

26

Comparison of two surface temperature measurement using thermocouples and infrared camera

Comparison of two surface temperature measurement using thermocouples and infrared camera

... measure surface temperatures at an experimental setup designed to analyse flow boiling heat ...two measurement methods employed to determine the surface temperature of the foil were: the contact ...

6

Dynamic measurement of surface charge

Dynamic measurement of surface charge

... Figure 6: Charge distribution for the first negative half cycle IO- 15ms As there is positive charge on the crystal, as soon as the applied voltage falls below zero negative charge is d[r] ...

5

Surface resistance calibration for a hydrological model using evapotranspiration retrieved from remote sensing data in Nahe catchment forest area

Surface resistance calibration for a hydrological model using evapotranspiration retrieved from remote sensing data in Nahe catchment forest area

... Model performance evaluation by comparing model-simulated outputs with corresponding observations is fundamental to hydrological model calibration. For decades, remote sensing images were frequently used for ...

6

Show all 10000 documents...

Related subjects