• No results found

three-port vector network analyzer

Methods for the calibrated measurement of the scattering parameters of planar multi-port devices

Methods for the calibrated measurement of the scattering parameters of planar multi-port devices

... As vector network analyzers (VNA) with two measurement ports and four measurement channels are still widely used in laboratories and industry, methods for the error-corrected scattering parameter ...

7

Multi-Layer Substrate Integrated Waveguide E-Plane Power Divider

Multi-Layer Substrate Integrated Waveguide E-Plane Power Divider

... Abstract—A new multilayer power divider with Substrate Integrated Waveguide (SIW) technology is proposed. In this work, two-way and four-way power divider realizations by two-layer and three-layer SIW, ...

14

CHARACTERIZATION OF X-BAND MICROWAVE COMPONENTS USING VECTOR NETWORK ANALYZER E5071C

CHARACTERIZATION OF X-BAND MICROWAVE COMPONENTS USING VECTOR NETWORK ANALYZER E5071C

... reciprocal three or four port ferro magnetic device , in which microwave or radio frequency power entering any port is transmitted to the next port in rotation ...a port is coupled to ...

8

Study on Small Signal Modeling of GaN HEMT Devices

Study on Small Signal Modeling of GaN HEMT Devices

... uses vector network analyzer (VNA) to measure S parameters under different biases at different frequency points, and uses the distributed extraction method to extract the parasitic parameters and ...

5

Optical fibre couplers

Optical fibre couplers

... By contrast, power variation due to an asymmetric input is more complex with up to three simultaneous length scales. Four cases are illustrated in Fig. 3.11, corresponding to R = 0.1, 0.8, 0.95 and 10, ...

266

Network Delay: Network Analyzer and 
                      Opnet Simulation Tool

Network Delay: Network Analyzer and Opnet Simulation Tool

... Network Editor is used to specify the physical topology of a communications network, which define the position and interconnection of communicating entities, i.e., node and link. The specific capabilities ...

7

TO ORDER COPIES OF THIS MANUAL Call: AT&T Customer Information Center on 1-800-432-6600. In Canada Call 1-800-255-1242

TO ORDER COPIES OF THIS MANUAL Call: AT&T Customer Information Center on 1-800-432-6600. In Canada Call 1-800-255-1242

... Two Port Network—The Processor Port Network (PPN) Containing the System’s Control, Software, and Trunk/Terminal Circuit Packs and the Expansion Port Network (EPN) Containing the ...

43

Small Size Active Antenna for VHF Band

Small Size Active Antenna for VHF Band

... The circuit in figure (1) is implemented in the RF spice software. The network analysis mode is selected from the TEST option. In the network analysis mode connections were given between input and output ...

5

W-Band Microstrip-to-Waveguide Transition Using via Fences

W-Band Microstrip-to-Waveguide Transition Using via Fences

... is 90 µm to result in a 50 Ω characteristic impedance for an alumina substrate of thickness H = 100 µm. For the design, the diameter of the via hole is 75 µm. The transmission characteristics of this transition is mainly ...

10

Virtual Machine Introspection: Security Architecture Overview

Virtual Machine Introspection: Security Architecture Overview

... Various network activities are controlled by the network controller which consists of various VM ...involves three modules which are VMI Agent, Attack Analyzer, and Network ...

7

C13 136 Codex Series 6000 pdf

C13 136 Codex Series 6000 pdf

... CON FIGURATION Each 6030 Series Basic Processor includes one to three processor modules, one network port module with a IS-foot network port cable, and sufficient buffer storage and Conf[r] ...

14

KXJ11 CA prelimUG 1986 pdf

KXJ11 CA prelimUG 1986 pdf

... Master Interrupt Control Register Master Configuration Control Register Port A Interrupt Vector Register Port B Interrupt Vector Register Counter/Timer Interrupt Vector Register Port C D[r] ...

236

Genetic Algorithm Optimized Electromagnetic Band Gap Structure for Wide Band Noise Suppression

Genetic Algorithm Optimized Electromagnetic Band Gap Structure for Wide Band Noise Suppression

... A three-layer PCB stack-up as shown in Fig. 4 is considered for SI analysis, and the MEO and MEW are determined in two cases, one with the EBG power plane and the other without the EBG plane. The stacked ...

7

Determination of the Complex Permittivity Values of Planar Dielectric Substrates by Means of a Multifrequency PSO-Based Technique

Determination of the Complex Permittivity Values of Planar Dielectric Substrates by Means of a Multifrequency PSO-Based Technique

... measurements. The input data for the reconstruction process have been measured at the frequencies f 1 = 1.0 GHz, f 2 = 1.5 GHz, f 3 = 2.0 GHz, f 4 = 2.5 GHz, and f 5 = 3 GHz with a vector network ...

9

NETWORK DELAY: HOW RELIABLE NETWORK ANALYZER SOFTWARE DEVELOPMENT

NETWORK DELAY: HOW RELIABLE NETWORK ANALYZER SOFTWARE DEVELOPMENT

... Real network environment has configured to enable network delay over ...fluke network analyzer to the server. Network management tool such as ColaSoft Capsa and Visualware application ...

7

Space vector modulated three level inverters with a single Z source network

Space vector modulated three level inverters with a single Z source network

... Z-source network was implemented using ...Z-source network was connected to an existing NPC inverter to generate the expected five-level output line-to-line voltage ...

27

An Evaluation of West and Central African Ports to Serve as a Hub on the Gulf of Guinea Container Ports Range

An Evaluation of West and Central African Ports to Serve as a Hub on the Gulf of Guinea Container Ports Range

... which port along the Gulf of Guinea can serve as a hub port for the West and Central African ...was port indexing which takes into account port classification, port capacity, ...

21

Comparison of Open-Ended Coax and TDR sensors for the measurement of soil dielectric permittivity in microwave frequencies

Comparison of Open-Ended Coax and TDR sensors for the measurement of soil dielectric permittivity in microwave frequencies

... The probe in the TDR method is a waveguide consisting of two or three parallel metal rods inserted into the tested medium. The velocity of propagation of the pulse in this waveguide, v, is modified by the ...

8

Comparative Study of Network Protocol Analyzer and Existing Tools

Comparative Study of Network Protocol Analyzer and Existing Tools

... use network traffic logger, it is a single window application that makes things very simple to work in, it breaks each device into three views: DNS, Http and Other TCP, DNS will show just hostnames and ...

6

Measurement consistency and the effect of ground planes on common mode crosstalk

Measurement consistency and the effect of ground planes on common mode crosstalk

... In order to isolate the behaviour of the boards, the VNA has to be properly calibrated. This was done by performing a SOLT calibration and then using the ”Remove Adapter” setting of the VNA to calibrate post the CM ...

8

Show all 10000 documents...

Related subjects