• No results found

tunnel design

A Low Cost Numerical Simulation of a Supersonic Wind-tunnel Design

A Low Cost Numerical Simulation of a Supersonic Wind-tunnel Design

... the design process of the wind-tunnel, firstly geometry of the nozzle is specified by the method of ...Then, design parameters of the diffuser (convergence and divergence angles, area of the throat, ...

8

Tunnel design and construction process in difficult ground conditions with Analysis of Controlled Deformations (ADECO) approach; a Case Study

Tunnel design and construction process in difficult ground conditions with Analysis of Controlled Deformations (ADECO) approach; a Case Study

... conveyance tunnel with a length of 10617 meters is currently under construction using conventional (350 m, T1 section) and mechanized (10267 m, T2 section) methods in the High Zagros zone, which is near the Main ...

12

Using topology optimization in tunnel reinforcement design

Using topology optimization in tunnel reinforcement design

... In tunnel reinforcement design, having a suitable tool which is able to capture complex ground material and various tunnelling conditions is definitely signifi- ...best design to be ...in ...

22

Optimization Design of Open Circuit Wind Tunnel Suction Type

Optimization Design of Open Circuit Wind Tunnel Suction Type

... and design of the wind ...the design, the proportionality of the size to the test chamber, while ensuring the fluid flow characteristic as ...wind tunnel design adopts a subsonic type with an ...

11

Theoretical study and design of a new calorimetric tunnel

Theoretical study and design of a new calorimetric tunnel

... calorimetric tunnel with lower power and smaller size, a new tunnel of higher power and better parameters was ...The tunnel was proposed on the base of 1D analytical calculations respecting wide ...

7

Using topology optimization in tunnel reinforcement design

Using topology optimization in tunnel reinforcement design

... In tunnel reinforcement design, having a suitable tool which is able to capture complex ground material and various tunnelling conditions is definitely signifi- ...best design to be ...in ...

162

Creating a decision support matrix for the design of a submerged floating tunnel

Creating a decision support matrix for the design of a submerged floating tunnel

... the tunnel would ...reference design was designed with inclined tethers in the ...reference design can be found in Figure 26 and a more detailed view in chapter ...

66

Design, Fabrication and Testing of Smoke Wind Tunnel

Design, Fabrication and Testing of Smoke Wind Tunnel

... for design parameters and calculation for dimensions of various parts of the wind ...tunnel. Design calculations allow wind velocities in the range of 1-3 m/s at the test ...The design ...

6

Design of Mini Wind Tunnel Based on Coanda Effect

Design of Mini Wind Tunnel Based on Coanda Effect

... wind-tunnel design is a complex field involving many fluid mechanics and engineering ...complete design of low-speed wind tunnels was that due to ...wind tunnel [2–4] have led to increase ...

7

Design and Comparative Analysis of Single Gate Tunnel FET and MOSFET

Design and Comparative Analysis of Single Gate Tunnel FET and MOSFET

... This work has been analysed thoroughly about the subthreshold swing performances of advanced Tunnel FET devices of 32nm gate length with the MOSFET. The TFET has lower OFF-current than the traditional MOSFET, each ...

7

A CRITICAL ANALYSIS OF DESIGN OF EARTH AIR TUNNEL HEAT EXCHANGER

A CRITICAL ANALYSIS OF DESIGN OF EARTH AIR TUNNEL HEAT EXCHANGER

... air tunnel heat exchanger is an interesting subject of passive heating or passive cooling ...preliminary design of EATHE which are recently being ...The design analysis also manipulated by ...

8

Design and Development of Low Speed Probe Calibration Wind Tunnel

Design and Development of Low Speed Probe Calibration Wind Tunnel

... of design optimisation, using Computational Fluid Dynamics (CFD) to model the ...of tunnel are inclined, length of tunnel, the flow rate of blower, and the curvature at the contraction ...

9

A validated design methodology for a closed-loop subsonic wind tunnel

A validated design methodology for a closed-loop subsonic wind tunnel

... the design and simulation of the flow parameters in a closed-loop subsonic wind tunnel was carried out by incorporating Computational Fluid Dynamics ...wind tunnel was considered instead of the ...

31

Development of tunnel diode devices and models for circuit design and characterization

Development of tunnel diode devices and models for circuit design and characterization

... All of the epitaxial structures grown for this work was done by Dr. Phillip E. Thompson, and therefore was a critical member of the team. His great knowledge of layer growth was invaluable for the design and ...

112

Twin-tunnelling-induced changes to clay stiffness

Twin-tunnelling-induced changes to clay stiffness

... An engineer could estimate the settlements above a twin-tunnel arrangement using Equation (3) given details of the geometry, geology and values for the Volume Losses. Therefore, guidance on what values would be ...

25

Twin-tunnelling-induced changes to clay stiffnesses

Twin-tunnelling-induced changes to clay stiffnesses

... Tunnels used for transportation in the urban environment are often constructed in pairs. Projects where tunnels are constructed sequentially and within a close proximity are referred to as ‘Twin- tunnelling’. Case ...

25

Design and characterization of layered tunnel barriers for nonvolatile memory applications

Design and characterization of layered tunnel barriers for nonvolatile memory applications

... 6. R. J. Twieg, M. He, L. Sukhomlinova, F. You, W. E. Moerner, M. A. Diaz-Garcia, D. Wright, J. D. Casperson, R. Wortmann, C. Glania, P. Kraemer, K. Lukaszuk, R. Matschiner, K. D. Singer, V. Ostoverkhov, and R. Petschek, ...

5

Design and Analysis of Gate All Around Tunnel FET based SRAM

Design and Analysis of Gate All Around Tunnel FET based SRAM

... several issues which include: poor ON current, ambipolarity and unidirectional conduction. The problem of poor ON state current has been solved by fabricating TFETs using lower energy band gap materials, for example: ...

9

Investigation of a
Venturi as a pump
application to an Antarctic
Sublimation system

Investigation of a Venturi as a pump application to an Antarctic Sublimation system

... Corrections for Wind Tunnel Effects The fact that the testing was conducted in a wind tunnel effects the results measured in the tests, the insertion of the model in the tunnel cause the[r] ...

109

Development of a dynamic wind tunnel rig for aircraft pure pitching motion

Development of a dynamic wind tunnel rig for aircraft pure pitching motion

... This paper presents the design , fabrication and testing of a dynamic wind tunnel test rig that is used in conjunction with aircraft dynamics theory in estimating aerodynamics stability [r] ...

12

Show all 10000 documents...

Related subjects