18 results with keyword: 'extreme manual version published october copyright asrock reserved'
F9:Setup Defaults F10:Save & Exit +/-:Change Values Enter:Select Sub-Menu :Select Item Peripheral Configuration Auto Disabled Auto ECP + EPP 1.9 Auto Disabled 5 200H Both
N/A
Installing OS on a HDD Larger Than 2TB in RAID Mode This motherboard is adopting UEFI BIOS that allows Windows ® OS to be installed on a large size HDD (>2TB). Please follow
N/A
3. Boot your system. Please make sure that the value you select is less than the total capability of the system memory. If you do not adjust the UEFI setup, the default value
N/A
Please notice that Ultra Fast mode will boot so fast that the only way to enter this UEFI Setup Utility is to Clear CMOS or run the Restart to UEFI utility in Windows. Boot
N/A
CLRCMOS1 allows you to clear the data in CMOS. To clear and reset the system parameters to default setup, please turn off the computer and unplug the power cord from the power
N/A
The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When
N/A
This allows user to select the LBA mode for a hard disk > 512 MB under DOS and Windows; for Netware and UNIX user, select [Off] to disable the LBA mode2.
N/A
F9:Setup Defaults F10:Save & Exit +/-:Change Values Enter:Select Sub-Menu :Select Item Peripheral Configuration Auto Auto ECP + EPP 1.9 Auto Auto Disabled 5 200h Both Enabled
N/A
Even some SATA / SATAII / SATA3 HDDs provide both SATA 15-pin power connector and IDE 1x4-pin conventional power connector interfaces, the IDE 1x4-pin
N/A
SATA Operation Mode IDE1 Master IDE1 Slave SATAII_1 SATAII_2 SATAII_3 SATAII_4 SATAII_5 SATAII_6 [Enabled] [non-RAID] [Hard Disk] [Not Detected] [Not Detected] [Not Detected]
N/A
F9:Setup Defaults F10:Save & Exit +/-:Change Values Enter:Select Sub-Menu :Select Item Peripheral Configuration Auto Enabled Auto Normal N / A Auto N / A Disabled 5
N/A
Please notice that Ultra Fast mode will boot so fast that the only way to enter this UEFI Setup Utility is to Clear CMOS or run the Restart to UEFI utility in Windows. Boot
N/A
According to your settings in Rapid Start Technology Manager, the system will automatically wake up and enable Rapid Start mode ater entering sleep... state for a period
N/A
2. Then connect other monitor cables to the corresponding connectors of the add-on PCI Express VGA card on PCIE1 slot. Boot your system. If you do not adjust the UEFI
N/A
Even some SATA / SATA2 / SATA3 HDDs provide both SATA 15-pin power connector and IDE 1x4-pin conventional power connector interfaces, the IDE 1x4-pin
N/A
Advanced SATAII Configuration SATAII 1 SATAII 2 SATAII 3 SATAII 4 SATAII 5 SATAII 6 IDE1 Master IDE1 Slave eSATAII [Enhanced] [Hard Disk] [Not Detected] [Not Detected] [Not
N/A