18 results with keyword: 'investigation of residual stress in selective laser melting'
It is clear from the triangle geometries shown in Figure 9.5(a-c), that the orientation of the scan vector used for hatching geometrical primitives has a significant effect on
N/A
microstructure on the bottom surface of the substrate remained unchanged during the SLM fabrication process. As previously mentioned, the contour and layer removal method measured
N/A
Keeping the Energy Density constant, 30x30x10mm Ti6Al4V blocks were manufactured for residual stress measurement, using different combination of power and exposure
N/A
Attendance at which the white house statement inf treaty shall have the inspection site diagrams appended to withdraw from the arms and inf.. Forming a white house statement inf
N/A
Power factor is the ratio of true power to apparent power. When the voltage and current phasors are identical to each other then only the power factor is
N/A
The residual stress distribution of the formed part was predicted, and the influence of process parameters such as exposure time, laser power and laser scanning speed on the
N/A
Technologies such as Selective Laser Melting (SLM), Electron Beam Melting (EBM), and Direct Metal Deposition (DMD) etc. utilise metal powders as feedstock material to produce parts.
N/A
At the beginning of the scan vector, a larger region is subjected to a compressive transverse stress when using the alternating strategy, as shown in Figure 19(a), compared to the
N/A
(1987) Ideas for Teaching Economics Derived from Learning Theory: Theory Into Practice, Developing Economic Literacy, 26(3), pp.176-182. •
N/A
The site allows users to upload, view, rate, share and comment on videos, and it makes use of WebM, H.264/MPEG-4 AVC, and Adobe Flash Video technology to display a wide variety
N/A
6 research supported in part by the National Research Foundation of South Africa (NRF) for the grant 80561. The authors also acknowledge the Erasmus Mundus scholarship funded
N/A
GeoGebra is an interactive mathematics software for teaching mathematics and science, including algebra, geometry, calculus, and statistics.. GeoGebra was created by Markus
N/A
As the studied material, there were chosen solid samples built in two different directions: parallel (P-L) and perpendicular (P-R) to the tested surface and cellular lattice built
N/A
Effect of heat treatment on AlSi10Mg alloy fabricated by selective laser melting: microstructure evolution, mechanical properties and fracture mechanism.. Selective laser melting
N/A
Through examining the influence of social contexts and alcohol consumption on individual risk-taking, the study found that group contexts increased risk-taking
N/A
Selective laser sintering and selective laser melting are powder based additive manufacturing (AM) process that can rapidly manufacture parts with comparable
N/A
The parameters used during additive melting (SLM) of a layer are the standard SLM values for AISI 316L optimized for maximum density (scan speed 380 mm/s, laser power 105 W,
N/A