[PDF] Top 20 Liquid-Liquid Interfacial Imaging Using Atomic Force Microscopy

... the liquid interface vertical position as a function of time and evaluate the frequency of the gravity waves excited during AFM acquisition which is ...the liquid– liquid interface (Figure 2b), ... See full document

... Potential applications of atomic force microscopy (AFM) in textiles are explained. For this purpose samples were carefully selected from both natural and synthetic fibers. Cotton, wool, conventional ... See full document

... C. Force measurements were performed at room temperature with a commercial AFM (Nanoscope IIIa/Multimode AFM) in PBS ...buffer. Force curves were acquired by using tips functionalized with p53, as ... See full document

... recorded using a Bruker UV/Vis ...slide. Atomic force microscopy (AFM) studies were performed using an Explorer ...Fluorescence microscopy studies were performed using a ... See full document

... an imaging tool, but was later modified to be operated in the force scan mode ...the force of the interaction to be ...unbinding force of a single ligand-receptor interaction using this ... See full document

... In the past, cell probe assays have been increasingly used to understand the cellular interactions of medically important or- ganisms, i.e., probiotics and pathogens. The nonspecific and spe- cific forces engaged in the ... See full document

... the force curve shows a jump which is interpreted as the maximum local force that a single nanoparticle can withstand before being displaced (red arrow in ...discontinuity force value depends on the ... See full document

... Many of the past rheological techniques were developed to investigate the viscoelastic properties of the whole cell in suspension. Global techniques such as the micropipette aspiration, optical tweezers, and the optical ... See full document

... The work herein clearly shows that practical AFM fluid cells operating at the range of flow rates defined in the literature offer relatively low interfacial mass transport rates. This is the case even if the ... See full document

... Figure 2 (A) β-cells are in Kr2 low glucose medium encapsulated in graphene liquid cells. cells are hermetically sealed between two biocompatible monolayers of graphene by the van der Waals forces. (B) False ... See full document

... contrast. Atomic force micros- copy (AFM) complements EM in a number of ...during imaging, and instead of the specimen being projected onto a plane, topographical features of a specimen’s surface are ... See full document

... in liquid, most systems relating to formulation engineering can be analysed under native ...and imaging modes in AFM are being developed, pushing the limits of AFM resolution, precision and scanning ... See full document

... directly using a laser beam (figure ...robust imaging of living cells at substantially higher speeds than traditionally possible (figure ...in liquid, while at the same time maintaining a small ... See full document

... nucleus-liquid interfacial energy is induced by a magnetic field which makes the arrangement of atoms on the interface more orderly than that without a ... See full document

... oscillatory decay of charge density and regions where the charge density decay is monotonic. The structural transition observed in SFB measurements appears to coincide (in terms of surface charge and compostion) with the ... See full document

... for imaging of nanoemulsions (Klanget ...imaged using a TEM cryoholder and cryo-electron microscopy of vitrified sections ...include using a gel such as agarose to solidify an aqueous ... See full document

... The liquid was injected radially into the air flow through 60 holes of 2 mm ...the liquid was returned back to a liquid storage tank upstream of a liquid circulation ...the liquid ... See full document

... Adhesion did not vary appreciably with cycling, was lower than predicted for metallic contacts, and supported chemical evidence of an initial C and O contamination layer on the surfaces. Changes to adhesion during ... See full document

... The 1-D models for solid-liquid-vapor phase change (Huang et al., 2009) are valid only if the laser spot size is much larger than the target thickness. If the above condition is not met, a multi-dimensional model ... See full document

... Polyvinyl Alcohol (PVA) is a hydrophilic and biocompatible polymer whose hydrogels are used for magnetic resonance imaging (MRI) and ultrasound phantoms, drug delivery systems, and wound dressings. Physically ... See full document